CYGNETT 911960 20000mAh ChargeUp Boost Power Bank User Manual
- June 4, 2024
- CYGNETT
Table of Contents
CYGNETT 911960 20000mAh ChargeUp Boost Power Bank
Caution Please read all warnings for your safety and optimal user experience. Please read and follow these instructions carefully and retain for your records.
- Disposal of a battery into fire or a hot oven, mechanically crushing or cutting of a battery, can result in an explosion.
- Leaving a battery in an extremely high temperature can result in an explosion or the leakage of flammable liquid or gas.
- A battery subjected to extremely low air pressure may result in an explosion or the leakage of flammable liquid or gas.
- The power bank will generate heat when charging. Always charge in a well-ventilated area.
- Do not charge under pillows, blankets or on flammable surfaces. Keep the power bank away from heat sources, direct sunlight, combustible gas, humidity, water or other liquids.
- Do not disassemble, open, microwave, incinerate, paint or insert foreign objects into the power bank.
- Do not subject the power bank to mechanical shock such as crushing, bending, puncturing or shredding.
- Avoid dropping or placing heavy objects on the power bank.
- Do not short circuit the power bank or store it in a receptacle where it may be short circuited by other metallic or conductive objects.
- Do not operate the power bank if it has been wet or otherwise damaged, to prevent against electric shock, explosion and/or injury. Contact the dealer or authorized agent.
- Usage of power bank by children should always be supervised.
Please note that changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment. Cygnett takes no responsibility for damages caused by incorrect use
of its products. Made in China. This symbol on the product indicates that this
product shall not be treated as household waste. Instead it shall be sent to
the applicable collection point for the recycling of electronic equipment. By
ensuring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and human health. For more
information about the recycling of this product, please contact your local
city office.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to connect the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Cygnett is a trademark of Cygnett Pty Ltd. Made in China.
Charge Your Device
Recharge your device(s) by connecting a compatible cable into the USB-A
output(s) (C/D) and/or USB-C output (E). Press the power button (A), and your
device(s) should begin to charge. When you are finished charging your
device(s), remove the cables from your power bank, and it will
turn off automatically.
To check the remaining charge on your power bank, press the power button (A)
once. The LED battery indicator (B) will showing the remaining charge from 0
to 100.
Recharge Your Power Bank
To recharge your power bank, use the included USB-C to USB-A cable, and connect the USB-A into a compatible USB-A charger, then insert the USB-C connector into the USB-C input (E). Alternatively, use a USB-C to USB-C cable and a USB-C charger. When recharging, the LED battery indicator (B) will flash, indicating the remaining charge.
- Power button
- LED battery indicator
- USB-A output
- USB-A output
- USB-C input & output
Product Specifications
- Name
- ChargeUp Boost
- 2nd Generation 20K
- Item Number
- CY3481PBCHE
- CY3482PBCHE
- CY3483PBCHE
- CY3484PBCHE
- CY3576PBCHE
- USB-A Output 1
- 5V⎓2.4A (12W)
- USB-A Output 2
- 5V⎓2.4A (12W)
- USB-C Output
- 5V⎓3A (15W)
- USB-C Input
- 5V⎓3A (15W)
- Total Output
- 15W Max
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>