Nedis AMLRMMW40WT Door Entry Motion Alarm User Manual
- June 5, 2024
- nedis
Table of Contents
AMLRMMW40WT Door Entry Motion Alarm
User Manual
Preface
Thank you for purchasing the Nedis AMLRMMW40WT.
This document is the user manual and contains all the information for correct, efficient and safe use of the product.
This user manual is addressed to the end user. Read this information carefully before installing or using the product.
Always store this information with the product for use in the future.
Product description
Intended use
The Nedis AMLRMMW40WT is a door entry alarm that detects movement using a CDS sensor. The product functions without the need of a receiver of reflector. The bundled detection beam prevents unnecessary alarms.
The product is intended for indoor use only.
Any modification of the product may have consequences for safety, warranty and proper functioning.
Specifications
Product
|
Door Entry Motion Alarm
---|---
Article number
|
AMLRMMW40WT
Dimensions (l x w x h)
|
85 x 82 x 40 mm
Weight
|
78 g
Detection angle
|
10 degrees
Sound level
|
80 dB (Chime)
Battery type
|
3 x AAA / LR03 (not included)
Safety instructions
WARNING
- Only use the product as described in this manual.
- Do not use the product if a part is damaged or defective. Replace a damaged or defective device immediately.
- Do not open the product.
- This product may only be serviced by a qualified technician for maintenance to reduce the risk of electric shock.
- Do not expose the product to direct sunlight, naked flames or heat.
- If battery fluid gets in your eyes, do not rub your eyes. Wash your eyes with clean water and immediately contact a physician.
- Do not expose the product to water or moisture.
- Do not drop the product and avoid bumping.
- Keep the product out of reach from children.
Installation
- Check the contents of the package
- Check that all parts are present and that no damage is visible on the parts. If parts are missing or damaged, contact the Nedis B.V. service desk via the website: www.nedis.com.
Installing the product
- The product is designed to illuminate when a person enters the detection area. There is no warranty or representation that it will provide security or prevent illegal entry.
- Not suitable for usage in the dark, or facing a strong light.
- The mounting bracket allows the sensor to be set at an angle of more than 300° so that it can be used as a wall or ceiling device.
For installation to the wall
1. Install the product ~50 cm above the ground with the detector facing across the door opening.
Maintenance
- Clean the product regularly with a soft, clean, dry cloth. Avoid abrasives that can damage the surface.
- Do not use aggressive chemical cleaning agents such as ammonia, acid or acetone when cleaning the product.
- The product will self-activate frequently to indicate that the battery is low; then it’s time to replace new batteries.
- If the product doesn’t work properly, replace the battery.
- Remove the batteries during long periods of disuse to avoid possible leakage.
Warranty
Any changes and/or modifications to the product will void the warranty. We accept no liability for damage caused by improper use of the product.
Disclaimer
Designs and specifications are subject to change without notice. All logos, brands and product names are trademarks or registered trademarks of their respective owners and are hereby recognized as such.
Disposal
|
This symbol indicates that this product should not be thrown away with other household waste throughout the EU. To prevent possible harm to the environment or human health by uncontrolled waste disposal, you are responsible for recycling it so that it can promote the sustainable reuse of raw materials. To return your used product, you can use the regular return and collection systems or contact the store where the product was purchased. They can recycle this product for the environment.
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>