Maxxima MCL-091705 9 Inch Round 5CCT Ceiling Light Installation Guide
- June 5, 2024
- Maxxima
Table of Contents
Maxxima MCL-091705 9 Inch Round 5CCT Ceiling Light Installation Guide
-
Risk of electric shock – Disconnect power at the source before installation.
-
If you are unsure about the installation or the maintenance of the wall light, please consult an electrician.
-
Do not make or alter any holes in the wiring enclosure or modify any electrical componentry.
-
To insure personal safety, proper grounding of the electrical fixture is required.
-
The fixture must be wired in accordance with the National Electric Code and applicable local codes or ordinances.
INSTALLATION INSTRUCTIONS
Tools Needed: Screwdriver, wire nuts, electrical tape
Wiring and J Box Mounting Instructions
- Shut off power at the circuit breaker or fuse before installation.
- If you are replacing an existing fixture, remove and disconnect the old fixture first.
- Expose the power supply wires from the junction box.
- Using the screws provided, mount the plate as shown in Figure 1, using the appropriate mounting plate holes compatible with your junction box. Secure the bracket to the Junction Box, tighten as needed. Pass the supply wires through the center hole on the plate.
- On the back of the fixture, locate the CCT Selector Switch, use switch to the position marked with the desired CCT. See figure 2.
- Connect the white fixture neutral wire to the junction box neutral wire by using a wire nut. See Figure 3.
- Connect the black fixture hot wire to the junction box hot wire from switch by using a wire nut. See Figure 3.
- Connect the green fixture ground wire to the junction box ground wire using a wire nut, or to the junction box grounding screw. see Figure 3.
- Ensure that the wires are placed properly within the junction box. Apply electrical tape as needed.
- Align the mounting plate with the slots on the back of the fixture, and twist to secure the fixture in place. See Figure 4.
Wiring and Recessed Housing Mounting Instructions
- Shut off power at the circuit breaker or fuse before installation.
- If you are replacing an existing fixture, remove and disconnect the old fixture first.
- Connect the torsion springs onto the mounting plate. See Figure 1.
- Attach the mounting plate onto the fixture. See Figure 2.
- Connect the E26 connector to the fixture by twisting a wire nut on the hot (black) wires and a wire nut on the neutral (white) wires. See Figure 3.
- Screw the E26 connector into the socket inside the recessed housing. See Figure 3.
- On the back of the fixture, locate the CCT Selector Switch, and select your desired CCT. See Figure 4.
- Insert the torsion springs inside the recessed housing until they sit firm in the slots of the recessed housing. Seeing Figure 5.
- Tuck all wires inside the housing and carefully push the fixture into the recessed housing. See Figure 6.
5 YEAR WARRANTY
Maxxima extends a 5 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
866-MAXXIMA (629-9462)
125 Cabot Court Hauppauge, NY 11788