AGPTEK XHY-160LED Motion Sensor Garage Light User Manual

**AGPTEK XHY-160LED Motion Sensor Garage Light User Manual

**

Please read this user manual carefully before use for proper use and keep it for further reference. Before first use, please expose the solar light to the sunlight for 6-8 hours for charging.

IMPORTANT:

The charging time and charging efficiency of solar panels are subject to the weather and installation location, so it’s recommended to install the product in a place with plenty of direct sunlight.

Package Contents

1 x Solar Light

1 x Sorew Set

1 x Remote Control

1 x Solar Panel

Product Overview

Remote Control Introduction

Modes Introduction

Night Mode

Mode 1:
Low-light Sensing Mode. Keep the light dim. It will ight up with high brightness for 20s when the motion of the human or animal is nimal detected in the sensing area, and will dim when the person or a leaves the sensing area for 20s. (works only at night)

Mode 2:
Motion Sensing Mode. It will ight up with high brightness for 20s when the movement of the human or animal is detected in the sensing area, and will go out when the person or animal leaves the sensing area for 20s. (works only at night)

Mode 3:
Always—on Mode. The lights turn on automatically at night and stay on,

Timing Mode:
24-hour Cycle Timing Function. For example, if the 2H timing function s turned on, the light will automatically go out after 2 hours; if the timer function is not turned off, the light will automatically tum on after 22 hours, continue to go out after 2 hours, and so on in a similar fashion.
2H: Timing 2 hours at 70% brightness
4H: Timing 4 hours at 60% brightness
6H: Timing 6 hours at 50% brightness

Day Mode

Mode 4 :
All Day Motion Sensor Mode. When the sensing area detects the movement of human or animals, it will light up with high brightness
for 20s, and after the person or animal leaves the sensing area for 20s, the light will turn off. (Can be used day and night)
Auto Mode :
Lights Up All Day. Autoratically switches to Mode 4 when the battery has 60% charge remaining. Then cycle the next day.

Notice:

1. Modes 1, 2, 3, 4, automatic mode and timing mode cannot take effect at the same time, only any one of them can take effect. To cancel the currently set mode, you can directly set other desired modes.
2. Brightness can be adjusted in any mode.

Specifications

Areas Not Suitable for Installation

Monitoring Area: The surveillance camera has infrared rays, which
will affect the the solar light.
Area with Short Light Hours: The soler light needs to install on a place with at least about 5 hours per day of sunlight exposure.

Area Under Strong Light: If there are strong lights on, the soler light may think it is daytime, thus, it may not automatically light up.
Area Under A Shelter: Installing in the shade or other places where sunlight cannot reach will affect the charging efficiency.

Cautions

1. Please place the product in a sunny place and charge it for a day if not in use for a long time. For better maintenance, it’s best to keep it in a sunny spot once every month
2. Please keep the switch ON when charging, otherwise it will not charge.
3. Avoid using the product in a high temperature, humid and corrosive environment for a long time, otherwise it will affect the service life
4. The product is waterproof and can withstand rainy weather and wet environments, but cannot be soaked in water.
5. Do not throw the battery into fire to avoid the risk of explosion

Maintenance

1. Please keep the solar panel clean and regularly wipe off the dust or other debris on the surface with a damp cloth. Excessive dust or deris can reduce the charging efficiency of the solar panel
2. 0n heavy snow days, the solar panel should be cleaned in time to avoid snow cover on the surface.

FAQ

keep the switch ON and recharge
The switch is not turned ON while charging| Cover the solar panel withyour hand, if the light is on, the solar light is working properly. Please move and install it elsewhere.
Bad battery| Please contact us for help
Doesn’t light up at night| Check if the installation area has sufficient light during the day| Install in a place withssunlight, at least ensure that there is no blockage from 9:00 to 15:00 every day
The installation area is exposed to strong light or infrared light| Please stay away from strong light areas or infrared areas
Short working hours| No enough sunlight due to installation in a shady place or charging on cloudy days| Make sure the solar panel is exposed in sufficient direct sunlight to charge. In case of rainy dayswithout sufficientsunlight, the solar light will automatically return to the best working state after the weather clears up and is exposed to sunlight the next day.
Stop working after a short time(weeks/mont hs)| Charging efficiency will be affected as solar panel is covered with dust or debris| Clean the solar panel regularly to ensure adequate exposure to sunlight
Not getting enough sunlight for a long time| Move the the solar light and expose it to direct sunlight, ewithout being shaded.
Water leaks after heavy rain or snow| Please contact us for help
Bad battery

Manufacturer: Shenzhen XinHuiyuan Electronics Co., Ltd.
Address: 2/f, New Dongfeng 2nd Industrial Zone, Liguang Village, Siyan Street, Bauman District, Shenzhen City
Made in China
CE FCC ROHS WEEE

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>