BRExhaust 106-0185 Direct Fit Replacement Exhaust System Instruction Manual
- June 13, 2024
- BRExhaust
Table of Contents
BRExhaust 106-0185 Direct Fit Replacement Exhaust System Instruction Manual
STEP 1: (Carefully read all instructions before installation) Disconnect the vehicle’s battery before removal of the OEM exhaust system. This will prevent electrical accidents and will reset the computer if it applies to the vehicle. Remove existing exhaust system from the vehicle. Only remove parts that will be replaced. Clean existing flange with a wire brush to ensure proper sealing.
STEP 2: Attach item 5 to existing isolators
STEP 3: Connect item 2 and item 3 to existing exhaust and isolator STEP 4: Using item 4, connect item 3 and item 5
STEP 5: Connect item 2 to item 3 with item 1
STEP 6: Ensure new exhaust is not contacting any portion of the underbody of
the vehicle or drivetrain.
STEP 7: Tighten all clamps and bolts starting from rear of the vehicle. (DO
NOT EXCEED 30FT-LB WHEN TIGHTENING CLAMP AND CHECK ALL CLAMPS AFTER 50 MILES.
RETIGHTEN IF NECESSARY)
WARNING:
When working on, under, or around any vehicle exercise caution. Please allow
the vehicle’s exhaust system to cool before removal, as exhaust temperatures
may cause severe burns. If working without a lift, always consult vehicle
manual for correct lifting specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death could occur if safety
measures are not followed.
BRExhaust recommends professional installation for all products
Technical Support: 1-800-631-7271
BRExhaust — 1901 Corporate Ctr, Oceanside, CA 92056
www.brexhaust.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>