BEGA 66165 Wall Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
BEGA 66165 Wall Luminaire Instruction Manual
Dimension
Instructions for use
Application
Wall luminaire for many lighting tasks on or in buildings.
Ideal for places where a soft and uniform light distribution is required.
Product description
Luminaire made of aluminium alloy and stainless steel
BEGA Unidure® coating technology
Opal glass
Mounting plate with 3 fixing holes ø 6mm
Angle 120° · Pitch circle ø 85mm 2 cable entries for through-wiring of mains
supply cable ø 7-10.5mm
Connecting terminal 2.5@ with plug connection
Earth conductor connection
Lampholder E 27
Safety class I
Protection class IP 44
Protected against granular foreign bodies ≥ 1 mm and splash water
Impact strength IK05
Protection against mechanical impacts < 0.7 joule
– Safety mark
– Conformity mark
Weight: 3.8 kg
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
Installation and commissioning may only be carried out by a qualified
electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation.
If subsequent modifications are made to the luminaire, the person responsible
for these modifications shall be considered the manufacturer.
Lamp
Luminaire with screw base E 27
Lamp output max. 150 W
This product contains light source of energy efficiency class E
Supplied lamp
BEGA LED lamp 13590
LED Retrofit 12 W · 1400 lm · 3000 K
Luminaire efficiency: 83%
Additional BEGA LED lamps are available for this luminaire:
13 584 LED 7 W · 805 lm · 3000 K
13 586 LED 7 W · 805 lm · 3000 K dimmable
13 588 LED 8 W · 1055 lm · 3000 K
13 592 LED 12 W · 1400 lm · 3000 K dimmable
Detailed technical and lighting data for the lamps can be found in the data sheets on our website.
Installation
Undo screw at wall bracket.
Remove mounting plate from wall bracket.
Lead mains supply cable through the cable entry into the mounting plate.
Note position of application of the mounting plate »arrow down«.
Fix mounting plate with enclosed or any other suitable fixing material onto
the mounting surface.
It is absolutely essential to use the enclosed gaskets.
Make earth conductor connection and electrical connection.
Push plug into coupler up to the stop.
Note position of application the luminaire »arrow down«.
Place luminaire onto mounting plate, adjust and fix with screw.
Insert lamp.
Insert glass into glass holder plate and centre it.
Tighten fixing screws of glass holder plate evenly.
Make sure that the glass gasket is in correct position.
Relamping · Maintenance
Disconnect the electrical installation.
Open the luminaire and clean.
Use only solvent-free cleaning agents. Change the lamp.
Check the gasket and replace, if necessary.
Close the luminaire.
For cleaning, do not use high pressure cleaners.
Accessory
10 410 Corner block
Corner block for installation of wall lights on a house corner.
A separate instructions for use can be provided upon request.
Spares
Spare glass: 11 002 273 .1
LED lamp 3000K: 13 590
Lampholder: 63 000 105
Gasket: 83 000 417
BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden · info@bega.com · www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>