PERLEGEAR PGTVS09-E Swivel Table Mount for TV Instruction Manual
- June 1, 2024
- Perlegear
Table of Contents
PERLEGEAR PGTVS09-E Swivel Table Mount for TV
INSTRUCTION MANUAL
Tabletop TV Stand
[email protected]
www.perlegear.com
BEFORE GETTING STARTED, LET’S MAKE SURE THIS STAND IS COMPATIBLE.
- TV Bracket
- Tempered Glass Base l!D Support Pillar
- TV Plate
- Foot Pad
- Bottom Cover
- Gasket with 3 Holes II Bolt
- Bolt
- Washer
- Safety Lock
- Cable Clip
CONTENTS
INSTALLATION
SPACER AND BOLT CONFIGURATIONS
ATTACH THE TV BRACKETS TO YOUR TV 
- Center the brackets on the back of your TV [top to bottom]. The TV brackets must be securely fastened in place.
OPTION A
OPTION B 
OPTION C 
OPTION D 
Option D: For TVs with Protruding Cables
- Use spacers to create extra space between the TV and TV brackets.
OPTION E
- Option E: For TVs with Recessed Holes
Spacers need to fill in the recessed holes on the back of the TV while keeping the TV brackets as close to the TV as possible.
ASSEMBLING THE BASE
- TIP: Attach the foot pads [G] to the frosted side of the tempered glass base [02].
- Leave a small gap between the edge of the base and the foot pads.
STEP 3 SECURING THE TV PLATE TO THE SUPPORT PILLAR
Note: There are three choices for height adjustment. You can choose your
desired height position while connecting the TV plate [04] to the support
pillar [03].
STEP 4 MOUNTING THE TV ON THE TV PLATE
The TV brackets have three sets of hooks. Choose the appropriate hooks before
hanging 63 your TV. The #1 hooks will position your TV lower, while the #2
hooks will add extra height.
The #3 hooks will position your TV the highest.
Insert the safety locks [Ml into the upward-facing hooks located directly below the horizontal TV plate.
STEP 5 CABLE MANAGEMENT 
STEP 6 SWIVEL ADJUSTMENT
- If necessary, the TV can be swiveled manually. Only swivel the TV by the TV edges. Do not press on the screen.
- If the TV is difficult to swivel, remove the TV, and slightly loosen the nut. Do not over-loosen. Attach the TV and swivel.