LTE-M Gateway for Tork EasyCube Instruction Manual
- June 5, 2024
- TORK
Table of Contents
Gateway for Tork EasyCube ™
LTE-M
User and Installation Manual
Set-up gateway
1
- Screws or adhesive tape
2
- CLICK!
3
NOTE/TIP
- Install in a location with good access to a mobile network.
- Install as high up as possible.
- Install at least 1 meter (39″) away from water.
- Install at least 1 meter (39″) away from Wi-Fi equipment.
Lights & Buttons
- LED
- Button (for future use)
Colour LED
| What it means
---|---
Blue
| Blinking light.
Wait. The system is connecting.
Green
| Steady light. All is OK.
Red
| Steady light.
Error. Something is wrong with the connection.
NOTE/TIP
The LED can be difficult to see in direct sunlight. Try to cover the sunlight to improve readability.
Technical Specification
Type of communication|
802.15.4 , LTE-M, 2G
---|---
Frequency 802.15.4|
2.4 GHz
Peak Power|
10 Watt
Average Power|
0.7 Watt
Input Voltage|
5V @2A
Product component dimensions (mm/ inch)
ITEM | LENGTH | WIDTH | HEIGHT |
---|---|---|---|
Gateway | 134 mm/ 5.28″ | 86 mm/ 3.39″ | 25 mm/ 0.98″ |
Product weight (g/ ounce)
COMPONTENT | WEIGHT |
---|---|
Gateway | 171 g/ 6 oz |
Mounting bracket | 7 g/ 0.25 oz |
Environmental conditions
CONDITION | MINIMUM | MAXIMUM |
---|---|---|
Storage & transport temp. | +10 °C | +40 °C |
Storage & transport humidity | 65% Rh | 85% Rh |
Operating temp. | +15 °C | +45 °C |
Operating humidity (non-condensing) | 15% Rh | 90% Rh |
Pressure | 700 hPa | 1060 hPa |
Warnings
- Install at least 25 cm/ 10 inches from any person.
- Do not modify the gateway in any way (including painting it).
- Only use the power supply provided with the gateway.
- Only use SIM cards approved by Essity.
- If any of the contents of Tork EasyCube™ appears to be damaged or broken, contact Essity Customer Service at 1 866 722 8675, for North America. For Europe please contact your Essity representative.
Important
- Save this user manual for future reference.
- If any changes to the installation are necessary, please contact Essity for support.
- No changes or modification of this equipment is allowed.
- Gateway for Tork EasyCube™ must be returned to Essity after the end of its service life.
- Devices shown are not actual size.
Simplified EU Declaration Of Conformity
Hereby, Essity Hygiene and Health AB declares that the radio equipment Gateway for Tork EasyCube™ Gateway is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: www.torkglobal.com
Labelling symbols
The following symbols appear on your Gateway for Tork EasyCube™ or accessories and/or packaging:
WEEE-marking
Dispose of electrical components in accordance with your local regulations.
European Conformity mark
Instruction manual
Caution
Special care should be taken to ensure safety and efficiency. Failure to do so
could cause damage to equipment or lead to the receipt of incorrect data.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
This device contains licence-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
For Europe:
article number: 652901 www.torkglobal.com
For North America:
article number: 693940
FCC ID: 2ABK3-693940
Contains FCC ID: N7NWP77B
IC: 10866A-693940
Contains IC: 2417C-WP77B
www.torkusa.com
Version:
B
Essity Hygiene and Health AB
SE-405 03 Göteborg, Sweden
Visiting address: Mölndals Bro 2, Mölndal
For North America:
Distributed by Essity HMS North America Inc
2929 Arch Street
Suite 2600
Philadelphia, PA 19104
www.essity.com,
www.torkglobal.com
Made in Sweden
Documents / Resources
| TORK
LTE-M Gateway for Tork
EasyCube
[pdf] Instruction Manual
693940, 2ABK3-693940, 2ABK3693940, LTE-M Gateway for Tork EasyCube
---|---
| TORK
LTE-M Gateway for Tork
EasyCube
[pdf] Instruction Manual
693930, 2ABK3-693930, 2ABK3693930
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>