HD Ridez WB-FD175BD Steel Construction Drop Down Style Running Boards Installation Guide
- June 1, 2024
- HD Ridez
Table of Contents
HD Ridez WB-FD175BD Steel Construction Drop-Down Style Running Boards
PARTS LIST
PROCEDURE
REMOVE CONTENTS FROM THE BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY. ASSISTANCE IS RECOMMENDED.
- Start the installation under the Passenger/Right side of the vehicle. Locate the front factory mounting location along the inner side of the body, (Figure 1).
- Use a wire brush on the thread chaser die to remove excess paint and/or undercoating from all studs.
- Slide (1) Plastic Washer over each of the (3) factory mounting studs in the body panel, (Figures 2—4). panel and steel Mounting brackets. Do not in an eye racket out the Plastic Was hers.
- Select (1) Mounting Bracket. Attach the Bracket to the studs with (3) 8mm Flat Washers and (6) 8mm
- Repeat step 9, Allah the 2 Passenger Right Rear Mounting Brackets to the centre and rear mounting locations.
- Select the Passenger/Right Running Board. Attach the Running Board to the rear face of the Mounting Brackets with (6) 10mm Hex Bolts, (12) 10mm Flat Washers and (6) 10mm Nylon Lock Nuts, (Figure 5).
- Devel and adjust the Running Board and lighten all hardware.
- Do periodic inspections it the installation and make sure that all hardware is secure and flight.
- To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damage the finish. Use only mild soap to clean the Running Boards.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>