HD Ridez WB-JD116BD Steel Construction Drop Down Style Running Boards Installation Guide
- June 1, 2024
- HD Ridez
Table of Contents
HD Ridez WB-JD116BD Steel Construction Drop Down Style Running Boards
PARTS LIST
1
| Driver/Left DS4 Running Board
---|---
1
|
Passenger/Right DS4 Running Board
1|
Driver/Left Front Mounting Bracket
1
| Passenger/Right Front Mounting Bracket
1|
Driver/Left Rear Mounting Bracket
1
| Passenger/Right Rear Mounting Bracket
1|
Driver/Left Front Support Bracket
1
| Passenger/Right Front Support Bracket
1|
Driver/Left Rear Support Bracket
1
| Passenger/Right Rear Support Bracket
12|
10mm x 30mm Hex Bolts
24
|
10mm x 20mm OD x 2mm Flat Washers
12
| 10mm Nylon Lock Nuts
4|
8mm x 35mm Hex Bolts
4
| 8mm Lock Washers
4|
8mm x 28mm OD x 3mm Flat Washers
4
| 6mm Double Bolt Plates
8|
6mm x 22mm OD x 2mm Flat Washers
8
|
6mm Nylon Lock Nuts
PROCEDURE
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READINSTRUCTIONSCAREFULLY. FACTORY INSTALLED OR AFTERMARKET “ROCK RAILS,” SIDE STEPSORRUNNING BOARDS MUST BE REMOVED. ASSISTANCE IS HIGHLY RECOMMENDED
- Start installation on the Driver/Left side of the vehicle. Locate the (3) pairs of factory mounting holes along the pinch weld, (Figures 1 & 5).
- Select the Driver/Left Front Mounting Bracket. Attach the Mounting Bracket to the front location with (1) 8mm Hex Bolt, (1) 8mm Lock Washer and (1) 8mm Flat Washer, (Figures 1 & 2). Do not tighten hardware.
- Select the Driver/Left Front Support Bracket. Attach the Support Bracket to the pinch trim with (1) 6mm Double Bolt Plate, (2) 6mm Flat Washers and (2) 6mm Nylon Lock Nuts, (Figure 3). Attach the Support Bracket to the Mounting Bracket with (1) 10mm Hex Bolt, (2) 10mm Flat Washers and (1) 10mm Nylon Lock Nut, (Figure 4). Do not tighten hardware.
- Repeat Steps 1-3 to attach the Driver/Left Rear Mounting Bracket and Support Bracket.
- Select the Driver/Left DS4 Running Board. With assistance, attach the Running Board to the rear faces of the Mounting Brackets with (4) 10mm Hex Bolts, (8) 10mm Flat Washers and (4) 10mm Nylon Lock Nuts, (Figure 6). Do not tighten hardware.
- Level and adjust the Running Board and tighten all hardware.
- Repeat Steps 1-6 to attach the Passenger/Right 0S4 Running Board.
- Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used to clean the Running Boards.
Driver/Left side Installation Pictured
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>