HD Ridez WB-TS280SD Black OE Style Nerf Bars Running Boards Installation Guide
- June 1, 2024
- HD Ridez
Table of Contents
HD Ridez WB-TS280SD Black OE Style Nerf Bars Running Boards Installation
Guide
PARTS LIST:
| 1 | Driver/Left Side S6 Running Board | 6 | 8mm x 35mm Double Bolt Plates |
|---|---|---|---|
| 1 | Passenger/Right Side S6 Running Board | 12 | 8mm x 30mm Hex Bolts |
| 2 | Front Mounting Bracket | 24 | 8mm x 24mm OD x 2mmFlat Washers |
| 4 | Center/Rear Mounting Bracket | 12 | 8mm Lock Washers |
| 12 | 8mm Nylon Lock Nuts |
PROCEDURE:
- REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READINSTRUCTIONSCAREFULLY. ASSISTANCE IS HIGHLY RECOMMENDED.
- Starting on the Driver/Left side of the vehicle, remove the plastic plugs or hex bolts fromthefactorymounting location along the bottom of the body, **(Figures 1, 4 & 7).
**
-
Select the Front Mounting Bracket. Attach the Mounting Bracket to the front mounting locationwith(2)8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Figures 1—3).
Donot tightenhardware. -
Select (1) Center/Rear Mounting Bracket. Attach the Mounting Bracket to the center locationwith(2)8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Figures 4—6) . Donot tightenhardware.
-
Repeat Step 4 to attach (1) Center/Rear Mounting Bracket to the rear location, (Figures7 &8). Donottighten hardware.
-
Select the Driver/Left S6 Running Board. Select (3) Double Bolt Plates. Insert the Bolt Platesintothechannel in the bottom of the Running Board closest to the Brackets, (Figure 9).
Lift the RunningBoardup and guide the studs through the Brackets.
- Attach the Running Board to the Mounting Brackets with (6) 8mm Flat Washers and (6) 8mmNylonLock Nuts, **(Figure 10).
** Do not tighten hardware.
- Level and adjust the Running Board and tighten all hardware.
- Repeat Steps 2—8 to attach the Passenger/Right S6 Running Board.
- Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damagethefinish. Use only mild soap to clean the Running Boards
Driver/Left Side Installation Pictured
Documents / Resources
| HD
Ridez WB-TS280SD Black OE Style Nerf Bars Running
Boards
[pdf] Installation Guide
WB-TS280SD, WB-TS280BD, WB-TS280SD Black OE Style Nerf Bars Running Boards,
WB-TS280SD, Black OE Style Nerf Bars Running Boards, Style Nerf Bars Running
Boards, Nerf Bars Running Boards, Bars Running Boards, Running Boards
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>