Solar Lighting DIRECT SLDPIL0014-WW Modern Commercial Pillar Light Instructions
- June 1, 2024
- Solar Lighting DIRECT
Table of Contents
Solar Lighting DIRECT SLDPIL0014-WW Modern Commercial Pillar Light
Product Information
Specifications
- Product: Commercial Pillar Light
- Model No. : SLDPIL0014-WW
- Features:
1. Day/Night Sensor
2. 8-10 hours Operation per day
3. Surface Mounted Base
Product Usage Instructions
Important Notes
- Place the solar panel in an area with a minimum of 6 hours direct sunlight for optimal charging.
- On overcast/cloudy days, the solar panel will still charge but may not reach full capacity, affecting battery performance.
- Avoid installing the light fitting under street lights or porch lights to ensure proper day/night sensor functionality.
Installation Method
- Remove contents from packaging.
- Switch the light fitting ON using the supplied hex key (locate the ON/OFF button in the small hole on top of the fitting).
- Choose a location with maximum direct sunlight exposure during the day.
- Secure the pillar base in place using the supplied nuts and bolts.
Troubleshooting
Phenomenon | Cause | Inspection Method | Solution |
---|---|---|---|
Light won’t turn on | Switch hasn’t been turned on | Determine switch position, | |
turn it on | |||
The light only stays on for a short amount of time | Battery has run flat |
Charge the light in direct sunlight for 1-2 days, check
again|
| | |
Frequently Asked Questions (FAQ)
-
Q: How long does the battery last on a full charge?
A: The battery can last 8-10 hours per day on a full charge. -
Q: Can I replace the battery myself?
A: Yes, you can replace the battery by accessing the light and following the instructions in the manual. Alternatively, contact SLD Customer Service for assistance. -
Q: What should I do if the light doesn’t turn on even after charging in direct sunlight?
A: Check the switch position and ensure it is turned on. If the issue persists, contact customer service for further assistance. -
Q: Can I use this pillar light indoors?
A: It is recommended to use this pillar light outdoors in areas with direct sunlight exposure for optimal performance. Contact Customer Service at 1300 135 911 or visit www.solarlightingdirect.com.au for more information.
INSTRUCTION GUIDE
Commercial Pillar Light
Model No. SLDPIL0014-WW
PACKAGE CONTENTS
- 1 x Light Fitting
- 1 x Pack of Screws
FEATURES
- Day/Night Sensor
- 8-10 hours Operation per day
- Surface Mounted Base
INSTALLATION METHOD
- Remove contents from packaging
- Switch your light fitting “ON” by using the supplied hex key (there is a small hole in the top of the fitting where the “ON/OFF” button is situated) (Seen in FIGURE 1)
- Locate a position where your light will receive maximum direct sunlight during the day
- Using the supplied Nuts & Bolts, fix the pillar base in your desired location
IMPORTANT NOTES
- Please ensure you place your solar panel in a location where it can achieve a minimum of 6HRS DIRECT SUNLIGHT
- Be aware that on overcast/cloudy days, the solar panel will still charge. However, not as efficiently as a sunny day, so the battery may not reach full capacity. Therefore, your light may turn off earlier than specified
- It’s best not to install the fitting underneath a street light, porch light etc. because this may stop the automatic day-night sensor triggering and result in your lights not turning on.
TROUBLE SHOOTING
- Customer Service Number: 1300 135 911
- www.solarlightingdirect.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>