Maxxima MCL-3324900SN Oval Black LED Ceiling Mount Light Fixture Installation Guide
- June 1, 2024
- Maxxima
Table of Contents
Maxxima MCL-3324900SN Oval Black LED Ceiling Mount Light Fixture
WARNINGS
- Risk of electric shock – Disconnect power at the source before installation.
- If you are unsure about the installation or the maintenance of the wall light, please consult an electrician.
- Do not make or alter any holes in the wiring enclosure or modify any electrical componentry.
CAUTIONS
- To ensure personal safety, proper grounding of the electrical fixture is required.
- The fixture must be wired by the National
- Electric Code and applicable local codes or ordinance
- Min 90℃ Supply Conductors Les Fils D’alimentation 90℃
- Turn off the main power at the circuit breaker before installing the fixture, to prevent possible shock.
INSTALLATION INSTRUCTIONS
Tools Needed: Screwdriver, drill, wire nuts, electrical tape. If you are replacing an existing fixture, remove and disconnect the old fixture first.
- Place the canopy against the ceiling in the desired orientation and mark the locations of the mounting keyhole slots.
- If necessary, drill holes for drywall anchors in the marked locations and install the anchors.
- Expose the power supply wires from the junction box.
- Connect the green fixture ground wire to the junction box ground wire by using a wire nut.
- Connect the white fixture neutral wire to the junction box white neutral wire by using a wire nut.
- Connect the black fixture hot wire to the junction box black hot wire by using a wire nut.
- Ensure all wires are tucked properly into the J-box. Align screw holes on the canopy to the junction box.
- Using the provided mounting screws, secure the canopy to the J-box. Tighten the mounting screws until the canopy base is properly flush against the ceiling.
- Place the diffuser on the canopy. Then place the metal ring on the diffuser. Align the ring mount tubes so they pass through the holes the holes on the metal ring.
- Put the 4 decorative nuts onto the ring mount tubes to secure the ring and diffuser.
- The installation is complete. Restore power to the fixture and verify the fixture operates properly.
CCT Color Selection
Color Changing Temperature Adjustment, CCT (if desired).
-
Adjust CCT switches on each board according to the desired colour temperature as seen below.
-
All boards must be set the same way.
Note: The fixture is preset to 3000K from the factory. -
Power to fixture must always be turned OFF before adjusting CCT switches.
COLOR TEMPERATURE ADJUSTMENT SETTING
3 YEAR WARRANTY
- Risk of electric shock – Disconnect power at the source before installation.
- If you are unsure about the installation or the maintenance of the wall light, please consult an electrician.
- Do not make or alter any holes in the wiring enclosure or modify any electrical componentry.
CAUTIONS
- To ensure personal safety, proper grounding of the electrical fixture is required.
- The fixture must be wired under the National
- Electric Code and applicable local codes or ordinance Min 90℃ Supply Conductors Les Fils D’alimentation 90℃ Min
- Turn off the main power at the circuit breaker before installing the fixture, to prevent possible shock.
WARNINGS
Maxxima extends a 3-year limited warranty to the original purchase that the
products listed are free from defects in material and/or workmanship only.
Maxxima will replace any warrantied product with the original
consumer/purchaser if the product fails because of defects due to workmanship
and/or materials within the limited warranty period. Limited warranty is not
transferable and applies to the original installation of the Maxxima product.
This offer does not constitute in any way a product guarantee and Maxxima does
not hereby assume any obligation whatsoever beyond sending a free replacement
product.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>