Minka Lavery 5061-726 Kearney Park 1 Light Black and Soft Brass Bath Vanity with Clear Glass Shade Instruction Manual

Table of Contents

Vanity with Clear Glass Shade

Minka-Lavery-5061-726-Kearney-Park-1-Light-Black-and-Soft-Brass-Bath-Vanity-
with-Clear-Glass-Shade-fig-1

Specifications:

Installation Instructions:

Shut off power at the fuse box or circuit breaker box and remove old fixture, including mounting hardware.
Carefully unpack your new fixture and lay out all parts in a clear area. Take care not to misplace any small parts necessary for installation.
Attach mounting plate (A) to junction box using junction box screws (B) (SIZE: #8-32N, L0.5). The side of mounting plate marked GND must face out.

Connecting the Wires:
Connect the electrical wires as shown in Fig. 2 below:

FIXTURE WIRES:

HOUSE WIRES:

Black (Hot)
White (Neutral)
Green (Ground)
Your installation is now complete. Return power and test the fixture.
Note: Illustration (Fig.1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.

Can I install the fixture without shutting off the power?
No, it is crucial to shut off the power at the fuse or circuit breaker before installation to avoid electrical hazards.
What should I do if I misplace small parts during unpacking?
It is recommended to contact customer support for replacement parts before proceeding with the installation.

Shut off power at the fuse box or circuit breaker box and remove old fixture, including mounting hardware.
Carefully unpack your new fixture and lay out all parts in a clear area. Take care not to misplace any small parts necessary for installation.
Attach mounting plate (A) to junction box using junction box screws (B) (SIZE: #8-32N, L0.5″). The side of mounting plate marked “GND”must face out.

Minka-Lavery-5061-726-Kearney-Park-1-Light-Black-and-Soft-Brass-Bath-Vanity-
with-Clear-Glass-Shade-fig-2

Connect the electrical wires as shown in Fig. 2, making sure that all wire connectors are secured. If your outlet box has a ground wire (green or bare copper), connect fixture’s ground wire to it. Otherwise, connect fixture’s ground wire directly to mounting plate (A) using green screw provided.
After wires are connected, tuck them carefully inside junction box.

Minka-Lavery-5061-726-Kearney-Park-1-Light-Black-and-Soft-Brass-Bath-Vanity-
with-Clear-Glass-Shade-fig-3

Place fixture body (C) over mounting plate (A), and secure with mounting screws (D).
Place glass shade (F) over socket (E) and secure with screw shell (G).
Install (1) one candelabra base bulb (H) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification—DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power and test the fixture.
Note: Illustration (Fig.1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.