Super Bright 15W LED White Flush Mount Downlight Instruction Manual
- June 2, 2024
- Super Bright
Table of Contents
Super Bright 15W LED White Flush Mount Downlight
PACKEAGE CONTENTS
- A 6 INCH LED DISK LIGHT 1
- B Wire Nuts 3
- C Screws 2
UNPACKING
Thoroughly inspect the fixture for freight damage. Freight damage should be reported to the delivery carrier.
DIMMER RECOMMENDATION
This unit may operate on other dimmers we haven’t tested with. (Input 120V 60Hz)
- LEVITON 6672, 6674, PD-6WCL, DSL06, MACL-153M//MA-R
- LUTRON TG-600PR-WH, S-600PR-WH, CTCL-153PDH-WH, TGCL-153PH-LA, SLV-600P-AL, SCL-153PH-WH, DVCL-153P, RNL06, MSCL-OP153M, IPL06
IMPORTANT
Please read carefully and save these instruction, as you may need them at a
later date. When using electrical equipment, basic safety precautions should
always be followed as below:
READ AND FOLLOW BELOW SAFETY INSTRUCTIONS
GENERAL: All electrical connections must be in accordance with local and National Electrical Code (N.E.C)standards. If you are unfamiliar with connections obtain the services of a qualified electrician.
- Risk of fire or electric shock.
- Disconnect main power at fuse or circuit breaker before installing or servicing the fixture.
- Do not make or alter any open holes in an enclosure of wiring or electrical components during kit Installation.
- To prevent wiring damage or abrasion do not expose wiring to edges of sheet metal or other sharp objects.
- This device is not intended for use with emergency exit.
- This fixture is 5%-100% dimmable. Please refer to a compatible dimmer list.
- Suitable for Locations.
- To prevent electrical shock, please wear rubber shoes and work gloves when installing the fixture.
INSTALLATION STEPS
- Make sure power off and the Junction Box is securely mounted before installation. (This disk light is compatible with 3.5″ Junction Box), see Figl.
- Remove lens by twisting clockwise, see Fig2.
- Remove the two stickers at the disk light back that read as 3.5″ Junction Box installation hole to reveal the screw slots. Select lamp color desired with the CCT switch, see Fig3.
- Connect the supply wires to the wires of disk light by using 3 wire nuts. Attach white to white, black to black, green to the ground wire, see Fig4.
- Arrange the wires into the Junction Box. Align appropriate slots in the disk light with the holes in the Junction Box. Use 2 screws to attach the disk light, flush with the ceiling, see FigS.
- Placing the lens back into it’s original position by twisting it in counter clockwise direction, see Fig6.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>