STREETLIFE SL2USBA0 USB Module for Charging Mobile Devices Instruction Manual
- June 6, 2024
- STREETLIFE
Table of Contents
STREETLIFE SL2USBA0 USB Module for Charging Mobile
**Devices Instruction Manual**
Streetlife reserves the right to modify the dimensions and specifications
Think before printing
Information for the installer
The installer must have the knowledge and competence to perform the installation safely and within the applicable standards. Local regulations and environmental conditions – to be determined by the installer – may affect the proper installation.
The installer is responsible for providing that the feed line to 1 (one) or more Power Charger USB modules is protected with a fuse or a circuit breaker of maximum 4 Ampere.
The Power Charger USB has to be connected to a DC power supply source of 24V. The Power Charger USB has been tested with 24V +/- 15 %. Therefore a minimum of 20,4V and a maximum of 27,6V.
Depending on the number of connected Power Charger USB devices the capacity of the supply voltage source needs to be 1 Ampere per connected device. With a coincidence factor of 50% and a maximum power protection of 4 Ampere a maximum of 8 (eight) Power Charger USB devices can be connected parallel.
ATTENTION!
Under no circumstances can Power Charger USB devices be connected serialized!
User Instructions
The Power Charger USB may only be used for charging a rechargeable battery which is permanently mounted in a device. The user may only use cables that were delivered with the device or were provided by the manufacturer.
The maximum cable length is 3 m.
The output voltage of the USB-connector is 5Vdc.
The rated output current of the USB connector is 1 Ampere.
The output current depends on the connected device.
The user of the Power Charger USB can only plug a USB cable with a type-A connector into the USB connector. See image below.
In the case of a malfunction of the connected device or of the connected cable the current can be higher than 1 Ampere. The user should remove the cable from the USB connector from the Power Charger USB device.
Requirements
Minimal requirement for storage of wood:
Parts
Options
R&R-Charger needs to be positioned somewhere else?
STEP 1
STEP 2
Cable Casing
STEP 3
STEP 4
STEP 5
Certification is the most rigorous approval process for RF Devices with the greatest potential to cause harmful interference to radio services. It is an equipment authorization issued by an FCCrecognized Telecommunication Certification Body (TCB) based on an evaluation of the supporting documentation and test data submitted by the responsible party (e.g., the manufacturer or importer) to the TCB. Testing is performed by an FCC- recognized accredited testing laboratory. Information including the technical parameters and descriptive information for all certified equipment is posted on a Commission-maintained public database.
FCC ID: 2AXJL-SL2USBAO
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept any interference received, including interference that may cause undesired operation.
For Canada (See RSS-210 clause 5.11)
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
- this device may not cause interference and
- this device must accept any interference, including interference that may cause undesired operation of the device
