super bright LED FLCU-X1 Series LED Flood Lights User Manual
- June 4, 2024
- super bright LED
Table of Contents
super bright LED FLCU-X1 Series LED Flood Lights
Safety and Notes
- Product should be installed and serviced by a certified electrician in accordance with applicable national, state, and local building and electrical codes.
- To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures.
- Avoid looking directly into lamp when illuminated.
- Ensure all mounts are securely attached and will support the weight of the fixture. Failure to properly support fixture may result in damage or injury, for which the manufacturer does not assume responsibility.
Specifications
Specifications| FLCU-X1-50K100-SV| FLCU-X1-50K150-SV| FLCU-X1-50K200-SV|
FLCU-X1-50K240-SV
---|---|---|---|---
Operating Temperature| -22°–113° F (-30°–45° C)
IP Rating| IP66
Fixture Weight| 6.5 lb (2.9 kg)| 8.5 lb (3.9 kg)| 12.8 lb (5.8 kg)| 13.1 lb
(5.9 kg)
Check product label for specific electrical specifications related to installation. Improper installation will void warranty.
Wiring Diagram
Installation Instructions
- Use the mounting bracket to mark the mounting surface and drill holes as needed.
- Place studs in holes with a loosely threaded nut on the end or place bolts into the holes without fully tightening.
- Place the mounting bracket over the bolts/studs and push it flush with the wall, then tighten the nuts/bolts.
- Loosen adjustment screws. Rotate the light to the desired angle and tighten screws
Rev Date: V1 03/21/2022
4400 Earth City Expy, St. Louis, MO
63045 866-590-3533
superbrightleds.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>