WSTOO B07SSTCPSP Snorkel Mask User Manual
- June 16, 2024
- WSTOO
Table of Contents
User Manual
B07SSTCPSP Snorkel Mask
Preparation:
Make sure there is no sand on the mask or tube, if there has sand, use water to clear the breathing tube or mask, once the mask is clean then it is ready for use.
Checking the seal:
Pull the straps of the mask over your head and check the fit of the mask on your face, breath normally to check for any leaks, if you feel slight pressure change when you breathe, then you have a good seal, if not, please kindly adjust the mask wire size.
Using:
Once in the water, swim on the surface and breathe calmly through your mouth or nose, if you feel light-headed remove the mask immediately, keeping your chin slightly up will create the best breathing experience, if you feel any obstruction to your breathing, it may be due to the snorkel being covered in water temporarily, the dry top snorkel design will prevent water from entering through the top of the snorkel, if water leaks into your mask, simply lift your head out of the water and it will drain out of the chin valve, no need emove your mask to clear it of water.
Proper use:
Full face snorkel masks are designed for leisure surface snorkeling.
Serious freediving is not recommended. Strenuous swimming while wearing any
type of snorkel, including full face designs, is not recommended. Be sure to
take regular breaks while snorkeling. Also follow the buddy rule: never
snorkel alone.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>