060205PE ST2 Pro Segway Scooter User Manual
- May 15, 2024
- Segway
Table of Contents
060205PE ST2 Pro Segway Scooter User Manual
Diagram and Functions
Handlebar Functions
Dashboard
Speed Modes Introduction
Damper Adjustment
S (Slow rebound): Increase rebound resistance by rotating the Adjustment Knob
clockwise.
F (Fast rebound): Decrease rebound resistance by rotating the Adjustment Knob
counterclockwise.
Note: The damper is set to the default position before leaving the factory.
Please follow the steps above to adjust it according to your riding habits.
Specifications
[1] Warning: it is your legal duty to comply with your local traffic law and
regulations when using this product. In the Unites States, in certain States,
an electric kickscooter is not allowed to be used on public road (i.e., “on-
road” ), if its maximum speed capacity, weight and/or other features do not
comply with the mandatory requirements imposed by law. With respect to maximum
speed capacity restriction, certain States require that an electric
kickscooters’ maximum speed capacity shall be capped at / limited to a
specific miles per hour if it is for on-road use, and the cap / limit varies
in different States. By way of examples, the States that impose such maximum
speed capacity restriction include New York, Florida, Arizona, New Jersey etc.
In the event you intend to use this product on-road in a State that imposes
such maximum speed capacity restriction, you MUST select a proper lower speed
mode of this Product to assure that the product’s maximum speed capacity under
such speed mode complies with the law. In the event the maximum speed capacity
of the lowest speed mode of this product nevertheless exceeds the maximum
speed capacity restriction imposed by a State for on-road use, you shall not
use this product on-road in that State. Furthermore, a State may have other
law regulating on-road use of this product, such as maximum speed requirement
and/or helmet requirement. In addition to State law, there may be further
restrictions or prohibition on use of electric kickscooters by local law
and/or regulations. For off-road use of this product, there may be other
restrictions and/or limitations imposed by the property owner or others. The
App of the product may provide additional useful information related to this
matter.
Disclaimer: this is not a legal opinion or legal advice. The information
provided herein (including in the App) is for your
convenience and information purpose only. It is not intended to cover every
piece of law and/or regulation that may be
applicable to this product. Segway and Ninebot explicitly hereby disclaim any
and all warranty and/or representation, express or implied, related to
completeness, accuracy, up-to-date of such information. Segway and/or Ninebot
reserves the right but not obligation to correct, implement and/or update the
information. You shall use the information at your own risk. It is your sole
responsibility to learn and understand any and all the law and/or regulation,
requirements, prohibition, restriction and/or limitation imposed by either
law, government authority, court, private party or the others that may apply
to your use of this product.
[2] Range at 15.5 mph (25 km/h): Tested while riding with a full battery, 165
lbs (75 kg) load, 77°F (25°C), at the speed of 15.5 mph (25 km/h) on average
on pavement.
[3] Typical Range: Tested while riding with a full battery, 165 lbs (75 kg)
load, 77°F (25°C), at the speed of 24.9 mph (40 km/h) on average on pavement.
Common Failures and Solutions
Error: In the case of “Error” code, that means there is something wrong with
some certain parts of your vehicle, please contact after-sales service and
check whether your vehicle needs a repair.
Warning: In the case of “Warning” code, the vehicle still can be ridden, but
it is recommended to handle the problem in accordance with the corresponding
solution timely.
Certifications
This product is certified to ANSI/CAN/UL-2272.
The battery complies with UN/DOT 38.3.
The battery complies with ANSI/CAN/UL-2271.
Federal Communications Commission (FCC) Compliance Statement for USA
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any
interference received, including interference
that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s
authority to operate the equipment.
NOTE
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
Industry Canada (IC) Compliance Statement for Canada
This device complies with Industry Canada license-exempt RSS standard (s).
Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including
interference that may cause undesired operation of the device.
CAN ICES-3 (B)/NMB-3(B)
Model: 060205PE
FCC ID:
IC:
Trademark
Segway, Segway ST, Powered by Segway and Rider Design are trademarks of Segway
Inc. Apple, Apple Find My,
Apple Watch, Find My, iPhone, iPad, iPadOS, Mac, macOS and watchOS are
registered trademarks of Apple Inc.
Android is trademark of Google LLC. IOS is trademark or registered trademark
of Cisco in USA and in other countries.
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by Segway-Ninebot is under
license. Other trademarks and trade names are those of their respective
owners.
We have attempted to include description and instructions for all the
functions at the time of printing. However, due to constant improvement of
product features and the changes of design, etc., there may differ slightly
from the products you purchased. Please download the APP for Android or iOS
system and read the latest electronic version of the manual.
In addition to Segway SuperScooter ST, there are multiple series and models
with different functions of
Segway-Ninebot’s products and some of the functions mentioned herein may not
be applicable to your other
Segway-Ninebot’s products. Due to the constant updates of products, this
manual and the actual products may be slightly different in color, appearance,
etc. Actual product shall prevail when there is a discrepancy between the
actual product and the manual.
©2023 Ninebot (Beijing) Technology Co., Ltd. All rights reserved.
Scan the QR code to download the Segway-Ninebot app
Please download Segway-Ninebot App and activate your SuperScooter before riding.
The manufacturer reserves the right to make changes to the product, release firmware updates, and update this manual at any time.
Visit www.segway.com or check the Segway-Ninebot app to download the latest user materials. You must install the app, activate your scooter, and obtain the latest updates and safety instructions.
The pictures shown are for illustration purposes only. The actual product may vary.