Westinghouse 61197 LED Indoor Ceiling Light Instruction user guide
- June 4, 2024
- Westinghouse
Table of Contents
Westinghouse 61197 LED Indoor Ceiling Light Instruction
WARNING: ELECTRICAL SHOCK CAN RESULT IN SERIOUS INJURY.
Read and follow instructions exactly as shown. If instructions are unclear, do
not proceed. Contact a qualified electrician. Read all instructions before
beginning. Proper wiring is essential for safe operation of this fixture. When
cutting or drilling into walls or ceilings, do not damage electrical wiring,
gas lines, or water lines. If any of the fixture or wiring components are dam-
aged, do not install fixture. Return to place of purchase.
ASSEMBLY INSTRUCTIONS FOR INDOOR LIGHTING FIXTURE
Congratulations on your Westinghouse purchase. This fixture has been designed to give you many years of beauty and service. For questions and comments, please visit www.westinghouselighting.eu/contact-us and www.westinghouselighting.de/contact-us
NOTE: Carefully unpack fixture and parts. Make sure all parts are included before discarding any packing materials (see figure 1).
MOUNTING AND WIRING INSTRUCTIONS
NOTE: Line art shown may not exactly match the fixture enclosed. However,
the installation instructions do apply to this fixture.
The light source of this luminaire is not replaceable; when the light source
reaches its end of life the whole luminaire shall be replaced.
-
Turn off power at circuit box to avoid possible electric shock.
-
Place mounting bar (B) flush against ceiling at desired mounting location. Using outside mounting bar holes as a guide, mark where pilot holes are to be drilled.
-
Inset two plastic anchors (D) into the pilot holes (for drywall ceiling).
-
Align outside mounting bar holes with plastic anchors (D) (If applicable). Secure mounting bar (B) into place using wood screws (E)
-
Make an electrical connection by press/loose the “L“ and “N“ button on the terminal block (F) and inserting the live and neutral terminals.
-
Tighten terminal screws. Make sure there are no stray wires.
-
Raise fixture body (A) up to mounting bar (B). Twist and lock fixture body (A) into mounting bar (B) in the holder (C) on fixture body (A). (refer to Fig. 2)
-
Turn power back on at circuit box.
CLEANING AND CARE
To clean, wipe fixture with soft cloth. Clean glass with mild soap. Spray from chemical cleaners can discolor the finish of fixture. Do not use scouring pads, powders, steel wool or abrasive paper to clean this fixture.
Meaning of crossed-out wheeled dustbin
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact you local government for information regarding the collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the groundwater and get into the food chain, damaging your health and well-being. When replacing old appliances with new ones, the retailer is legally obligated to take back your old appliance for disposal at least free of charge.
Appliance specifications – TECHNICAL CHARACTERISTICS
| Rated voltage | 220-240V~ |
|---|---|
| Rated frequency | 50/60 Hz |
| Protection class | CLASS II |
| IP number | IP20 |
| Rated wattage | Item number |
| --- | --- |
| Integrated LED Max. 12W | 61197 |
| Integrated LED Max. 18W | 61198 |
| Integrated LED Max. 21W | 61199 |
References
- Contact Us
- Ceiling Fans | Lighting Fixtures | Lamps
- Ceiling Fans | Lighting Fixtures | Lamps
- Contact Us
- Ceiling Fans | Lighting Fixtures | Lamps
- Ceiling Fans | Lighting Fixtures | Lamps
- Contact Us
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>