niceboy RAZE Supersonic Wireless Speaker User Manual
- June 12, 2024
- niceboy
Table of Contents
niceboy RAZE Supersonic Wireless Speaker User Manual
PACKAGE CONTENTS
Niceboy RAZE Supersonic wireless speaker
USB-C charging cable
Audio cable
Instruction manual
PRODUCT DESCRIPTION
- Volume down / previous track button
- Volume up / next track button
- Control of lights
- On / Off Play / Pause
- TWS button / Change mode / Accept / End / Reject call
- AUX input jack 3.5mm
- Charging USB – output, input for USB flash drive
- Input for micro SD card
- Charging USB-C input
- Operating LED
CHARGING
We recommend fully charging the speaker before first use to maximize battery
life. A full charge takes approximately 3 hours. A low battery status will be
signaled by an acoustic signal. To charge the speaker‘s battery, connect the
supplied USB-C cable to the charging port (9) and connect to any charging
adapter (voltage 5V and output current at least 1A) or to USB in the PC. The
charging progress is signaled by the red charging LED (10), after full
charging the LED goes out.
ON/OFF
To turn the speaker on or off, press and hold the button (4) for 3 seconds.
If the speaker is not active, it will automatically turn off after 15 minutes
to save energy
CONNECTING TO THE DEVICE
- Press the on/off button. (4) for 3 seconds to turn on the speaker. The speaker is now in pairing mode for wireless connection. The pairing mode is signaled by the blinking of the operating LED (10).
- Activate Bluetooth on your device. Then select „Niceboy RAZE Supersonic“ in the list of available devices.
- The device connects to the speaker. Successful pairing will be announced by an acoustic prompt and the operating LED (10) will light up.
When you turn it on again, the speaker will automatically connect to the last paired device.
PLAYBACK
You can start or pause a song by briefly pressing the button (4). You control
the volume by briefly pressing buttons (1) and (2). Press and hold buttons (1)
and (2) to switch to the next or previous song.
AUX MODE
- Insert the included 3.5mm jack cable into the audio input (6) and the speaker will automatically switch to the appropriate mode.
- To control the music being played use the device you connected the speaker to. You can control the speaker volume by briefly pressing buttons (1) and (2)
USB FLASH DISK AND MICRO SD CARD
Insert the memory device into the corresponding port (7), (8). The speaker
will automatically switch to playback mode, which will be announced by an
acoustic prompt. You can start or pause a song by briefly pressing the button
(4). You control the volume by briefly pressing buttons (1) and (2). Press and
hold buttons (1) and (2) to switch to the next or previous track.
The device supports data
carriers with a maximum capacity of 32GB and audio format MP3, WMA, WAV.
FM MODE
Connect the supplied USB-C cable to the charging port (9), it serves as an
antenna. Long press the button (5), the FM mode will be announced by an
acoustic prompt; short press the button (4) to search and automatically store
stations. You end the automatic search with a short pressing the same button
(4). After the search is complete, switch between stations by long pressing
buttons (1) and (2).
PHONE CALLS
To accept and then end the phone call, press the button (5). Long press the
same button to reject an ncoming call.
LIGHTING MODE
Press button (3) to switch between individual color modes. Long press the same
button to turn off the light, long press to turn it back on.
Note: Higher energy consumption must be expected in active light mode.
TRUE WIRELESS (TWS) CONNECTION
Using True Wireless (TWS) technology, you can connect two Niceboy RAZE
Supersonic speakers together and play music simultaneously in stereo.
- Turn on both Niceboy RAZE Supersonic speakers and make sure they are not connected to any Bluetooth device (cell phone, laptop, etc.).
- Briefly press the button (5) on one of the speakers. An acoustic signal announces the successful completion of the speaker connection.
- Now you can open the Bluetooth settings of your device. Then select „Niceboy RAZE Supersonic“ in the list of available devices. Successful pairing will be announced by an acoustic signal.
FACTORY SETTINGS
In case of technical problems, reset the speaker to factory settings. The
speaker must be turned on. Press and hold the button (4) for 8 seconds. The
speaker will first turn off and then turn on again. Now the process is
finished.
PARAMETERS
- BT version: 5.0
- Frequency band: 2.4 GHz
- Radiofrequency power: ≤ 2.5 mW
- Transmission range: 10 meters
- Supported codecs: SBC
- Supported profiles: A2DP, AVRCP, HFP
- Power output: 16 W
- Impedance: 4 Ω
- Sensitivity: >88 dB
- Frequency range: 80 Hz – 20 kHz
- Supported data storage devices: USB flash drive, micro SD card, max. 32 GB
- Supported audio formats: MP3, WMA, WAV
- Battery: Li-Ion 1,800 mAh
- Battery life: 12 hours (at 50% volume)
- Waterproofness: IPX6
SAFETY INFORMATION
Listening to music at very high volume can damage your hearing. Do not expose the device to fluids or humidity. Do not expose the device to extreme temperatures or try to disassemble it. Protect the device from sharp objects and falls from height. Batteries – improper handling (prolonged charging, short circuit, breakage by other objects, etc.) may result in fire, overheating or battery leakage.
The battery or accumulator that may be included with the product has a service life of six months, as it is a consumable. The manual is available for download in electronic form at www.niceboy.eu in the support section. NICEBOY s.r.o. hereby declares that radio device type Niceboy RAZE Supersonic complies with Directives 2014/53/EU, 2014/30/EU, 2014/35/EU,and 2011/65/EU. The full EU Declaration of Conformity is available at the following website: https://niceboy.eu/en/raze-supersonic
INFORMATION FOR USERS ON DISPOSAL OF ELECTRICAL AND ELECTRONIC EQUIPMENT (HOUSEHOLDS)
The above symbol on the product or accompanying documentation means that used up electrical or electronic products must not be disposed of as communal waste. To dispose of the product correctly, bring it to designated waste collection points, where it will be disposed of free of charge. Proper disposal of the product helps preserve valuable natural resources and prevent potential negative impact on the environment and human health caused by improper waste disposal. For more information, contact local authorities or the nearest waste collection point. Improper disposal of this type of waste may result in a fine pursuant to national legislation.
Information for Users on Disposal of Electrical and Electronic Equipment (Corporate Use) To properly dispose of electrical and electronic equipment for corporate use, contact the manufacturer or importer of the product. They will provide you information on disposal methods for the product and will inform you on who is obligated to fund the disposal of the electrical device based on the date the product was put on the market. Information on Disposal in Countries outside the European Union. The above symbol only applies in EU countries. To properly dispose of electrical and electronic equipment, request more information from your local authority or the seller of the product.
Costumer Support
MANUFACTURER:
NICEBOY s.r.o., 5. kvetna 1746/22, Nusle, 140 00,
Praha 4, Czech Republic, ID: 294 16 876.
Made in China.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>