LOREX E871AB Halo Series H20 4K Dual Lens Wired Bullet Security Camera User Guide
- May 15, 2024
- Lorex
Table of Contents
**LOREX E871AB Halo Series H20 4K Dual Lens Wired Bullet Security Camera User Guide
**
Safety Precautions
- Follow all instructions for safe use and handling of the product.
- Use the camera within given temperature, humidity and voltage levels noted in the camera specifications.
- Do not disassemble the camera.
- Do not point the camera directly at the sun or a source of intense light
- Periodic cleaning may be required. Use a damp cloth only. Do not use any harsh, chemical-based cleaners.
- The supplied cable is rated for surface mounting only (Non-UL). Cables for in-wall and floor-to-floor installations are sold separately (CMR type). These and other cables are available at lorex.com.
- It is recommended to connect the camera to the NVR or an external PoE switch. If using a power adapter with this camera, a REGULATED power supply is REQUIRED (not included). Use of a non-regulated, non-conforming power supply can damage this product and voids the warranty.
Disclaimers
- Use the camera only with compatible Lurex recorders. For a full list, visex.com/compatibility.
- Not intended for submersion in water. Installation in a sheltered location recommended.
- This camera includes an Auto Mechanical IR Cut Filter. When the camera changes between Day/Night viewing modes, an audible clicking noise may be heard from the camera. This clicking is normal, and indicates that the camera filter is working.
- Audio recording and/or face recording without consent is illegal in certain jurisdictions. Corporation assumes no liability for use of its products that does not conform with local laws
Overview general
Camera Placement Tips
Important! Ensure the mounting surface can support at least 3 times your
camera’s weight.
Location: Place your camera in a wide, open space. Avoid placing it near any
obstructions. Height: Install your camera at a height of 10 ft (3 m) above the
ground. Angle: Angle your camera outwards by 15°. Avoid angles greater than
30°. Distance: Place your camera within 22-65 ft (7-20 m) of points of
interest.
Camera Mounting
- Use the mounting template to drill holes for screws, then insert the drywall anchors. Drill a hole for the camera’s cable if you plan to run it through the mounting surface.
- Use the screws to mount the camera base to the surface. If you are running cables along a wall/ceiling, make sure to pass the cable through the cable notch.
- Feed the camera’s cable through the camera base, then connect the cables (see page 12).
- Loosen the adjustment screws and position your camera as needed, then tighten to secure it in place.
- Remove the vinyl film from the camera lens once your installation is complete
Camera Connection
Connect your camera directly to your recorder using the camera’s Ethernet
extension cable.
Weather-resistant Cap
Twist the Ethernet extension cable’s pre-attached weather resistant cap securely onto your camera’s Ethernet connector. If exposed to regular precipitation, seal the cap with silicone and electrical tape.
Need Help
For related support, scan the QR code or visit: Pour oftener use assistance
connexon, bilayer le code QR out consulter le site : Para oftener assistance
relacionada, escapee el Código QR o visited
help.lorex.com/E871AB
Copyright © 2023 Lurex Technology Inc.
As our products are subject to continuous improvement, Lurex reserves the
right to modify product design, specifications and prices, without notice and
without incurring any obligation. E&OE. All rights reserved.
References
- Security Cameras - Home Security Camera Systems | Lorex
- Product Compatibility Chart - Expand Your System | Lorex
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>