Minka Lavery 5088-781-L Levitation 1 Light Sand Black and Soft Brass LED Island Chandelier Instruction Manual
- June 17, 2024
- MINKA LAVERY
Table of Contents
Minka Lavery 5088-781-L Levitation 1 Light Sand Black and Soft Brass LED Island Chandelier
PREPARATION (Fig.1)
- Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
- Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
ASSEMBLING THE FIXTURE (Fig. 1)
- Connect the cable and fixture body together by usings screws (I) on end of cables into coupling (J) on the fixture body.
- Adjust cable length to desired height and level by pushing on wire strainer.
- Position mounting plate (B) on ceiling and mark location of four drywall anchors (A). Pre-drill holes for drywall anchors (A). Then insert drywall anchors (A) into ceiling.
- Attach mounting plate (B) to junction box (not included) with mounting screws (D) (Size: #8-32N*L0.5”) and wood screws (G) into drywall anchors (A). The side of mounting plate (B) marked “GND” must face out.
- The support cable is provided to support the weight of fixture while wiring. Align fixture to mounting plate (B) and attach hook (H) on the end of support cable (N) and a slot located on mounting plate (B). Carefully allow support cable (N) to support weight of fixture while wiring.
CONNECTING THE WIRES (Fig. 2)
- Connect electrical wires as shown in Fig 3, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to mounting plate (B) using the green screw provided.
- Tuck wire connectors neatly into the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
- Place canopy (E) over mounting plate (B) and secure with screws (F).
Your installation is now complete. Return power to the junction box and test the fixture.
Note : Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
Dimmable with ELV and/or LED compatible wall dimmer switches.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>