KOZYARD KZCHG1012GY5 Caesar Hardtop Gazebo Instruction Manual
- June 17, 2024
- KOZYARD
Table of Contents
Enjoy Cozy Life!
10’x12’ Caesar Hardtop Gazebo
With Double Roof
Assembly Manual Kozyard LLC Products
www.kozyard.com
© Copyright 2016 – 2023 Kozyard LLC. | All Rights Reserved.
Version: 20231006
Warnings and Cautions
- Please read and follow this assembly and operation guide to reduce the risk of personal injury and damage to your gazebo.
- Do not discard any of the packaging until you have checked that you have all the parts in place. The maximum weight capacity of this gazebo roof is 2000 pounds.
- Sidewalls and nettings should be off or in the opened position and tied to poles when winds are over 30 MPH to avoid damage.
- Some parts may have sharp edges or corners. To ensure your safety, follow basic safety precautions to reduce the risk of injury. Please note that this item contains small parts which could be swallowed by children. Keep it out of reach of children under 3 years old and pets during installation.
Pre-assembly
Tools that may be required.(Not included in boxes)
Note: Tools are not shown to actual size and scale.Anchoring poles into
concrete is strongly recommended.
Ensure the gazebo is positioned on level ground
Attention: Prior to assembly, verify that all parts and pieces are
included to ensure an efficient installation process.
ITEM | DESCRIPTION | QTY |
---|---|---|
A5 | Pole | 4 |
D5 | Beam | 2 |
E5 | Beam | 2 |
D6 | Beam | 2 |
E6 | Beam | 2 |
F5 | Union Bar | 4 |
G5 | Corner Cover | 4 |
H1 | Joint Cover | 4 |
H3 | Double-sided adhesive tape | 1 |
H5 | Joint Cover | 4 |
L5 | Plate | 4 |
J5 | Corner Solidifyng Bar | 4 |
J6 | Corner Solidifyng Bar | 4 |
K | Inside Roof Connector | 1 |
K1 | Outside Roof Connector | 1 |
M5 | Corner Roof Bar | 4 |
N5 | Roof Bar | 4 |
P | Finishing Bar | 2 |
P1 | Net Frame | 2 |
Q | Finishing Bar | 2 |
Q1 | Net Frame | 2 |
Q2 | Net Frame | 2 |
R | Finishing End | 12 |
R1 | Finishing End | 4 |
ITEM | DESCRIPTION | QTY |
---|---|---|
R5 | Roof Bar Connector | 4 |
R9 | Finishing Bar | 2 |
R10 | Finishing Bar | 2 |
R11 | Finishing Bar | 2 |
R12 | Finishing Bar | 2 |
S | Spacer | 104+3 |
T | Finishing Bar | 2 |
T1 | Finishing Bar | 2 |
U0 | Solidifying Bar | 4 |
U | Solidifying Bar | 4 |
U3 | Iron Angle | 4 |
U4 | Iron Angle | 4 |
V1 | Roof Panel | 2 |
V2 | Roof Panel | 2 |
V3 | Roof Panel | 2 |
V4 | Roof Panel | 2 |
V5 | Roof Panel | 2 |
V6 | Roof Panel | 2 |
B11 | Roof Panel | 2 |
B12 | Roof Panel | 2 |
B13 | Roof Panel | 2 |
B14 | Roof Panel | 2 |
B15 | Roof Panel | 2 |
B16 | Roof Panel | 2 |
ITEM | DESCRIPTION | QTY |
---|---|---|
A11 | Roof Panel | 2 |
A12 | Roof Panel | 2 |
A13 | Roof Panel | 2 |
A14 | Roof Panel | 2 |
A15 | Roof Panel | 2 |
A16 | Roof Panel | 2 |
A17 | Roof Panel | 2 |
A18 | Roof Panel | 2 |
S1 &S2 | Solid Sidewall | 4 |
Y1 &Y2 | Mosquito Net | 4 |
SY | Strap | 4 |
Z | Bracket | 56+2 |
Z1 | Bracket | 4 |
Z2 | Bracket | 4 |
Z3 | Bracket | 4 |
Z4 | Bracket | 4 |
1# | Screws | 174+4 |
2# | Screws | 16+2 |
3# | Screws | 8+1 |
3#L | Screws | 16+2 |
4# | Hook | 104+3 |
5# | Screws | 64+3 |
6# | Screws | 8+1 |
7# | Screws | 28+2 |
9# | Screws | 24+2 |
10# | Screws | 4+1 |
11# | Screws | 8+1 |
Parts Required: Step 1: Set up Poles
- Set up Poles (Part A5) with Stand Plates (Part L5) using #1 as shown in the diagram.
Reference for anchoring gazebo:
- If the ground is concrete and its depth is over 3 inches, you can purchase 3/8″ diameter x 3″ length sleeve anchors.
- Only anchor after finishing all the assembly.
After assembly, we strongly recommend anchoring the gazebo to your deck or concrete as shown above. Damage resulting from wind or improper anchoring is not covered under warranty. Tips:
- Wearing protective gloves is recommended.
- To prevent Z-Clips (plastic brackets) from sliding off prior to assembly, apply dou- ble-sided adhesive tape (Part H3) to the underside (bottom) edge of the roof panels where the brackets (Part Z, Z1, Z2) are supposed to attach.
- You can use super glue (not included) to attach the brackets to the roof panel if the double-sided tape doesn’t work for you.
Tips:
- Wearing protective gloves is recommended.
- To prevent Z-Clips (plastic brackets) from sliding off prior to assembly, apply dou- ble-sided adhesive tape (Part H3) to the underside (bottom) edge of the roof panels where the brackets (Part Z, Z3, Z4) are supposed to attach.
- You can use super glue (not included) to attach the brackets to the roof panel if the double-sided tape doesn’t work for you.
Tips:
- Wearing protective gloves is recommended.
- To prevent Z-Clips (plastic brackets) from sliding off prior to assembly, apply double-sided adhesive tape (Part H3) to the underside (bottom) edge of the roof panels where the brackets (Part Z, Z3, Z4) are supposed to attach.
- You can use super glue (not included) to attach the brackets to the roof panel if the double-sided tape doesn’t work for you.
Care and Warranty
- Clean the frame components and fabric with a mild soap solution, then rinse thoroughly. Avoid using bleach, acid, or any other solvents on either the fabric or frame components.
- The roof, frame, bolts, and nuts come with a guarantee against defects in material and workmanship for one year from the date of purchase. However, the privacy curtain and mosquito netting are warranted for just 90 days. For a comprehensive warranty policy, please visit www.kozyard.com. Be aware that warranty terms can change without prior notification.
- For the best performance and safety of your gazebo, inspect and tighten all bolts and fasteners regularly
As expert manufacturer of hardtop gazebos, Kozyard remains committed to
supporting you with parts and replacements, even beyond your warranty period.
Don’t hesitate to contact us directly if you are missing parts or need a
replacement.
SUPPORT:
Toll free: 1-866-355-0018
www.kozyard.com
email: support@kozyard.com
SOCIAL MEDIA:
Follow us on Instagram
www.instagram.com/kozyard
KOZYARD LLC
© Copyright 2016 – 2023 Kozyard LLC. I Afl Rights Reserved.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>