KOZYARD KZCHG1212GY5 12 ft x12ft Caesar Hardtop Gazebo Instruction Manual

June 16, 2024
KOZYARD

KOZYARD-logo

KOZYARD KZCHG1212GY5 12 ft x12ft Caesar Hardtop Gazebo

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
product

Product Information

Specifications

  • Product Name: 12’x12′ Caesar Hardtop Gazebo With Double Roof
  • Manufacturer: Kozyard LLC Products
  • Website: www.kozyard.com
  • Version: 20231006

FAQ

  • Q: What tools are required for assembly?
    • A: Safety glasses, 12 in. anchor blueprint, and a 12 in. safety glasses are required.
  • Q: Is it necessary to anchor the gazebo?
    • A: Yes, anchoring the gazebo into concrete is strongly recommended to ensure stability.
  • Q: What is the warranty coverage?
    • A: Damage resulting from wind or improper anchoring is not covered under warranty.

Warnings and Cautions

  • Two or more people are required for assembly and disassembly.
  • Do not fully tighten screw prior to complete assembly.

Pracutions

Warnings and Cautions

  • Please read and follow this assembly and operation guide to reduce the risk of personal injury and damage to your gazebo.
  • Do not discard any of the packaging until you have checked that you have all the parts in place. The maximum weight capacity of this gazebo roof is 2000 pounds.
  • Sidewalls and nettings should be off or in the opened position and tied to poles when winds are over 30 MPH to avoid damage.
  • Some parts may have sharp edges or corners. To ensure your safety, follow basic safety precautions to reduce the risk of injury. Please note that this item contains small parts which could be swallowed by children. Keep it out of reach of children under 3 years old and pets during installation.
  • Two or more people are required for aseembly and disassembly.
  • Do not fully tighten screw prior to complete assembly.

Pre-assembly

Tools that may be required.(Not included in boxes)

Note: Tools are not shown to actual size and scale.

Parts And Tools

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-3

12’x12’ Anchor Blueprint

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-4

  • Anchoring poles into concrete is strongly recommended.
  • Ensure the gazebo is positioned on level ground.

Attention: Prior to assembly, verify that all parts and pieces are included to ensure an efficient installation process.

Parts And Tools

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-5 KOZYARD-KZCHG1212GY5-12-ft-x12ft-
Caesar-Hardtop-Gazebo-fig-6

ITEM DESCRIPTION QTY
A5 Pole 4
D6 Beam 4
E6 Beam 4
F5 Union Bar 4
G5 Corner Cover 4
H1 Joint Cover 4
H3 Double-sided adhesive tape 1
H5 Joint Cover 4
L5 Plate 4
J5 Corner Solidifyng Bar 4
J6 Corner Solidifyng Bar 4
K2 Inside Roof Connector 1
K12 Outside Roof Connector 1
M1 Short Corner Roof Bar 4
M6 Long Corner Roof Bar 4
N6 Roof Bar 4
R Finishing End 12
R1 Finishing End 4
R5 Roof Bar Connector 4
P2 Finishing Bar 4
P12 Net Frame 2
Q12 Net Frame 2
R11 Finishing Bar 4
R12 Finishing Bar 4
T2 Finishing Bar 4
U1 Solidifying Bar 8
U3 Iron Angle 4
U4 Iron Angle 4
S Spacer 116+3

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-7 KOZYARD-KZCHG1212GY5-12-ft-x12ft-
Caesar-Hardtop-Gazebo-fig-8 KOZYARD-
KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-fig-9

ITEM DESCRIPTION QTY
Z Plastic Bracket 72
Z1 Plastic Bracket 8
Z2 Plastic Bracket 8
S7 Solid Sidewall 4
Y7 Mosquito Net 4
SY Strap 4
V11 Roof Panel 4
V12 Roof Panel 4
B21 Roof Panel 4
B22 Roof Panel 4
B23 Roof Panel 4
B24 Roof Panel 4
B25 Roof Panel 4
B26 Roof Panel 4
B27 Roof Panel 4
B28 Roof Panel 4
1# Screws 185+4
2# Screws 16+2
3# Screws 8+1
3#L Screws 16+2
4# Hook 112
5# Screws 72+3
6# Screws 8+1
7# Screws 32+2
9# Screws 24+2
10# Screws 4+1
11# Screws 8+1
12# Washer 12+1

Installation Instructions

Step 1: Set up Poles

  • Set up Poles (Part A5) with Stand Plates (Part L5) using screws #1 as shown in the diagram.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-10

Step 2: Connect the Beams

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-11

Step 3: Set up Poles and Beams

  • Use screws 3#L and 3# first, then use screw 2# to connect Poles and Beams together as shown in the diagram.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-12

Step 4: Connect Solidifying Bars wtih Beams and Poles

  • Affix the frame with Corner Solidifying Bars (Parts J5, J6) using screws 1# as shown in the diagram.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-13

Step 5: Cover the connections

  1. Finish Connecting Beams using Corner Covers (Part G5) and screws 9# as shown in the diagram.
  2. Affix middle beams using Joint Cover (Part H5) and screws 9# as shown in the diagram.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-14

Step 6: Install Hooks

  • After finishing Hooks (Part 4#) into the tracks, then put Joint Cover (Part H1) to lock them.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-15

Step 7: Connect Corner Roof Bar “M7”

  • Connect the Short Corner Roof Bar (Part M1) with Long Corner Roof Bar (Part M6) using screws 1# and washer 12#.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-16

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-17

Step 9: Set up Roof Bar

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-18

Step 10: Connect Outside Roof Connctor

  • Connect Out side Roof Connector (Part K12) to Inside Roof (Part K2) using screw 1# as shown in the diagram.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-19

Step 11: Snap Brackets

  • Snap Bracket (Part Z, Z1, Z2) to the roof panel edges as shown in the diagram. (with snaps facing upwards)

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-20 KOZYARD-
KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-fig-21

Tips

  1. Wearing protective gloves is recommended.
  2. To prevent Z-Clips (plastic brackets) from sliding off prior to assembly, apply double-sided adhesive tape (Part H3) to the underside (bottom) edge of the roof panels where the brackets (Part Z, Z1, Z2) are supposed to attach.
  3. You can use super glue (not included) to attach the brackets to the roof panel if the double-sided tape doesn’t work for you.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-22 KOZYARD-
KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-fig-23

Step 12: Assemble Roof Panels

  1. Push the Roof Panels (Part V11, V12) to upper roof as shown in the diagram.
  2. Attach Finishing Bars (Part T2) to upper roof with Finish End (Part R) using screws 1# as shown in the diagram.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-24

Step 13: Connect Solidifying Bars

  • Attach Solidifying Bars ( Part U1) to roof bar or corner roof bar using Iron Angle (Part U3, U4) and screws 1# as shown in the diagram.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-25

Overall roof assembly

  • Please place the panels on the frame and assemble them from the centerline (Part N6) to the left and right.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-26

Step 14: Affix roof panels using screws and Spacers (Part S) as shown in the diagram.

  • Align all roof panels and screws LOOSELY (DO NOT TIGHTEN ANY SCREWS) until all the roof panels are aligned accordingly, THEN TIGHTEN all screws to secure the roof panels in place.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-27 KOZYARD-
KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-fig-28

Step 15: Cover edge of roof

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-29

  1. Attach F inishing bars (Part R11, R12) to Roof bar and Corner Roof bar.
  2. Then put Finshih End (Part R, R1) to cover them using screws 1# as shown in the diagram.

Step 16: Assemble Net Frame

  • Attach Net Frames (Part P12) to Finishing Bars (Part P2) using screws (1#, 11#) as shown in the diagram.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-30

Step 17: Assemble Net Sidewall

  • Hang the Mosquito Net on the inner rails and the Solid Sidewalls on the outer rails as shown in the diagram.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-31

Step 18: When closing the Mosquito Net, refer to the steps below to align it with the poles, as shown in the diagram.

KOZYARD-KZCHG1212GY5-12-ft-x12ft-Caesar-Hardtop-Gazebo-
fig-32

Care and Warranty

  • Clean the frame components and fabric with a mild soap solution, then rinse thoroughly. Avoid using bleach, acid, or any other solvents on either the fabric or frame components.
  • The roof, frame, bolts, and nuts come with a guarantee against defects in material and workmanship for one year from the date of purchase. However, the privacy curtain and mosquito netting are warranted for just 90 days. For a comprehensive warranty policy, please visit www.kozyard.com. Be aware that warranty terms can change without prior notification.
  • For the best performance and safety of your gazebo, inspect and tighten all bolts and fasteners regularly.

As expert manufacturer of hardtop gazebos, Kozyard remains committed to supporting you with parts and replacements, even beyond your warranty period.
Don’t hesitate to contact us directly if you are missing parts or need a replacement.

SUPPORT

SOCIAL MEDIA: Instagram

WWW.KOZYARD.COM

© Copyright 2016 – 2023 Kozyard LLC. | All Rights Reserved.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

KOZYARD User Manuals

Related Manuals