Maxxima MEW-USB482C USB Wall Outlet Receptacle Instruction Manual
- June 16, 2024
- Maxxima
Table of Contents
Maxxima MEW-USB482C USB Wall Outlet Receptacle
Product Information
Specifications
- Model: MEW-USB482C
- Type: TR Wall Outlet
- Ports: USB-A and USB-C
- Warranty: 1 year
- Contact:[email protected]
- Phone: 866-MAXXIMA (629-9462)
- Website:www.maxximastyle.com
- Address: 125 Cabot Court Hauppauge, NY 11788
Product Usage Instructions
Installation
Before installing the TR Wall Outlet, please read and follow these instructions:
- Make sure the power is turned off at the circuit breaker before starting the installation.
- Remove the existing wall outlet cover plate.
- Disconnect the wires from the old outlet.
- Connect the wires to the corresponding terminals on the TR Wall Outlet. The black wire goes to the brass terminal, the white wire goes to the silver terminal, and the green or bare copper wire goes to the green terminal.
- Screw the TR Wall Outlet onto the electrical box using the provided screws.
- Attach the wall outlet cover plate to complete the installation.
Charging Devices
To charge devices using the USB ports on the TR Wall Outlet, follow these steps:
-
Make sure the TR Wall Outlet is properly installed and the power is turned on.
-
Connect your device’s USB cable to either the USB-A or USB-C
port on the TR Wall Outlet. -
Plug the other end of the USB cable into your device.
-
Your device will start charging automatically.
Safe Usage
To ensure safe usage of the TR Wall Outlet, please keep the following in mind:
- Do not overload the TR Wall Outlet by connecting too many devices at once.
- Keep the TR Wall Outlet away from water and other liquids.
- If any abnormality is noticed, such as sparks or smoke, immediately turn off the power and contact a qualified electrician.
- Do not attempt to disassemble or repair the TR Wall Outlet yourself. Contact customer support for assistance.
Maintenance
The TR Wall Outlet requires minimal maintenance. To keep it clean, simply wipe it with a dry cloth. Do not use any abrasive or corrosive materials for cleaning.
FAQ
Q: Can I charge multiple devices simultaneously?
- A: Yes, you can charge multiple devices at the same time by connecting them to the USB ports on the TR Wall Outlet.
Q: Does the USB-C port support fast charging?
- A: Yes, the USB-C port on the TR Wall Outlet supports fast charging for compatible devices.
Q: What is the maximum power output of the USB ports?
- A: The combined maximum power output of the USB-A and USB-C ports is 4.8 amps.
Q: Is the TR Wall Outlet compatible with both 110V and 220V electrical systems?
- A: Yes, the TR Wall Outlet is compatible with both 110V and 220V electrical systems.
PARTS INCLUDED
WARNING:
- This product may represent a possible shock or fire hazard if improperly installed or attached in any way.
- The product should be installed under the owner’s manual, current electrical codes, and/or the current National Electric Code (NEC).
- RISK OF ELECTRIC SHOCK: TURN OFF THE MAIN POWER AT THE CIRCUIT BREAKER BEFORE INSTALLING. RISK OF FIRE:
- DO NOT EXCEED ELECTRICAL RATINGS
- USE INDOORS ONLY
TAMPER RESISTANT RECEPTACLES
Built-in shutter keeps children safe.
- This device is to be installed in an outlet box that measures at least 3in x 2in x 2.5in and is wired under NEC article 314 box fill requirements.
CAUTION:
- This device is to be used with Class 2 USB connectors and interconnecting cables.
- The Class 2 USB ports are not intended to physically support products or appliances.
- The Class 2 USB cables must be routed away from the 120V receptacles and inserted plugs
- This device is to be used with copper or copper-clad wire only.
CAUTION:
- To reduce the risk of fire and overheating, check for compatibility with the appliance manufacturer’s charging instructions.
Installation
- WARNING: SHOCK HAZARD. MAY RESULT IN SERIOUS INJURY OR DEATH. TURN OFF THE POWER AT THE CIRCUIT BREAKER BEFORE INSTALLING.
- IF YOU’RE UNFAMILIAR WITH PROPER ELECTRICAL WIRING PLEASE CONTACT A QUALIFIED ELECTRICIAN
- TURN POWER OFF
- Turn the power off at the circuit breaker or remove the fuse.
- REMOVE EXISTING OUTLET
- Take off the wall plate and outlet by removing the mounting screws.
- Carefully pull out the outlet from the wall.
- Label wires connected to the existing outlet box and disconnect wires.
- STRIP WIRES
- Strip wires to 5/8 inch if necessary. Use with #1#12 AWG copper or copper-clad wire.
- WIRE YOUR NEW OUTLET
- Wire device as shown below.
- Use a screwdriver to secure wires to terminals.
- INSERT OUTLET INSIDE THE OUTLET BOX
- Position all wires inside the outlet box with care, leaving enough room to insert the device.
- Use provided mounting screws to attach the device securely inside the outlet box.
- ATTACH THE FACE PLATE TO THE OUTLET
- Place the wall plate over the device.
- Gently push the wall plate to ensure a flush fit.
- Secure the plate onto the outlet using provided screws.
- TURN POWER ON
- Turn the power on at the circuit breaker or replace the fuse.
1 YEAR WARRANTY
Maxima extends a 1-year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxima will replace any warrantied product with the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxima product. This offer does not constitute in any way a product guarantee and Maxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.
FCC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference,
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
866-MAXXIMA (629-9462)
125 Cabot Court Hauppauge, NY 11788
Documents / Resources
|
Maxxima MEW-USB482C USB Wall Outlet
Receptacle
[pdf] Instruction Manual
MEW-USB482C USB Wall Outlet Receptacle, MEW-USB482C, USB Wall Outlet
Receptacle, Wall Outlet Receptacle, Outlet Receptacle, Receptacle
---|---