Z-Lite 517PHB-BK-LED LED Black Outdoor Post Mount Fixture Instruction Manual

Z-Lite 517PHB-BK-LED LED Black Outdoor Post Mount Fixture

FOR YOUR SAFETY WARNING

BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKINGON IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF. GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully. If you are unclear as to how to proceed, consult a qualified electrician. NOTE: Proper wiring is essential for the safe operation of this fixture.

ASSEMBLY INSTRUCTIONS

517PHM-LED & 517PHB-LED

READ & SAVE

INSTALLATION & OPERATION INSTRUCTIONS TOOLS & MATERIALS REQUIRED

Screwdriver Wire Cutters
Adjustable Wrench Wiring Supplies

CAUTION

Prior to assembly, refer to ELECTRICAL CONNECTIONS section. If you do not haveelectrical wiring experience, refer to a do-it-yourself wiring handbook or have your fixture installed by a qualified licensed electrician.

GENERAL

1. Be sure to read these instructions and review the diagrams thoroughly before beginning.
2. Electrical connections must be in accordance with local codes, ordinances, or theNational Electric Code. If you are unfamiliar with methods of installing electrical wiring, secure the services of a qualified licensed electrician. 3. Before starting the installation, disconnect the power by turning off the circuit breaker or by removing appropriate fuse at fuse box. Turning the power off at thelight switch is not sufficient to prevent electrical shock.
   

PREPARE THE FIXTURE

NOTE: First turn off electricity

FINAL ASSEMBLY

1. Pull the black, white and ground wires out of mounting post.

2. While supporting the fixture, connect electrical wires. If your post has a groundwire(green or bare copper), connect the fixture ground wire to it. If not, consult your electrician for proper grounding.
   ELECTRICAL CONNECTIONS 120V~, 60Hz
   Connect white wire(s) from fixture to white neutral wire from supply circuit. Connect black wire(s) to black hot wire from supply circuit. Connect green wire togreen or bare wire or grounding screw on mounting bracket. In all cases groundingconductor to earth must be used. Use UL/CSA Listed wire connects suitable for thesize, type, and number of conductors. No loose strands or loose wires should bepresent. Secure wire connectors with UL/CSA Listed electrical tape. After wires are connected, tuck them carefully inside the post cup.

3. Align the lantern with mounting post and secure with screws

4. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turnthe light switch on to activate the fixture.

5. LED replacement. Take down the screw(1) and glass(2), unscrew the screw(3) andloosen the quick connector (4) to replace the LED module, then connect the quick
   connector (4) and secure the LED module by screw (3), finally secure the glass (2) byscrews (1).

CAUTION: LED fixtures can operate at high temperaturesplease use caution when touching during operationor after operation.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>