Maxxima MRL-S40925B 6 in. 5 CCT Ultra-Thin Recessed LED Gimbal Downlight Instruction Manual

: June 15, 2024
: Maxxima

Table of Contents

WARNING / ATTENTION
Hole Cut-out Diameter
Parts List
Electrical parameters:
Installation Guide:
Three Year Warranty:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Maxxima MRL-S40925B 6 in. 5 CCT Ultra-Thin Recessed LED Gimbal Downlight Instruction Manual

The units covered in these instructions are intended to retrofit Type IC or Type Non-IC luminaries.

WARNING / ATTENTION

Risk of fire. Supply conductors (power wires) connecting to the fixture must be rated 90° C. If uncertain, consult an electrician.
Risk of fire or electric shock. LED Retrofit Kit installation requires knowledge of luminaries electrical systems.
Risk of fire or electric shock. If not qualified, do not attempt installation. Contact a qualified electrician.
Risk of fire or electric shock. Install this kit only in the luminaires that have the construction features and dimensions shown in the photographs and/or drawings.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
This lamp is not intended for use with emergency exit fixtures or emergency lights.

CAUTIONS

For your safety read and understand instructions completely before starting installation.
Before attempting installation, check your local electric code, as it sets wiring standards for your locality.

NOTES

If luminaire (fixture) is to be switched from a wall switch, make sure black power supply wire is connected to the switch. DO NOT connect the white supply wire to the switch.
Make sure no bare wires are exposed outside the wire nut connectors.
Do not make or alter any open holes in an enclosure of wiring or electrical comp nonets during kits installation.

Hole Cut-out Diameter

Parts List

Electrical parameters:

Installation Guide:

Turn off the power before installation. Remove the existing fixture if applicable.
Determine the location and necessary hole cut-out diameter using the supplied table and cut the ceiling hole with the listed approximate diameter. (Fig. 1)
Open the DRIVER/JUNCTION BOX cover and remove the appropriate knockout(s) on the side panel (Fig. 2). Install the appropriate cable clamp(s) (not included) and insert the electrical supply cable through the cable clamp. Connect the ground wire to the green wire terminal, hot wire to the black wire terminal and neutral wire to the white wire terminal using the push-in terminal connectors provided.
Place all wiring and connections back into the box and close the cover. Connect the DRIVER/JUNCTION BOX to the light panel using the CONNECTOR.
Use the CCT selector switch on the outside of the DRIVER/JUNCTION BOX to select the desired CCT color of the light.
Insert DRIVER/JUNCTION BOX through the mounting hole (Fig. 3) and secure using mounting tabs.
Push the SPRING-LOADED CLIPS into the mounting hole upwards and insert LIGHT PANEL into it. Release the clips and the fixture will be pulled flush to the ceiling. (Fig 4)

Three Year Warranty:

Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/ purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.