Z-Lite 579XL-BK Talbot 12 3 Light Black Stainless Steel Outdoor Wall Sconce Instruction Manual
- June 15, 2024
- Z-Lite
Table of Contents
579XL-BK Talbot 12 3 Light Black
Stainless Steel Outdoor Wall Sconce
Instruction Manual
579XL-BK Talbot 12 3 Light Black Stainless Steel Outdoor Wall Sconce
ASSEMBLY INSTRUCTIONS
579XL 579B
READ & SAVE
INSTALLATION & OPERATION INSTRUCTIONS
TOOLS & MATERIALS REQUIRED
- Screwdriver
- Wire Cutters
- Adjustable Wrench
- Wiring Supplies
CAUTION
Prior to assembly, refer to ELECTRICAL CONNECTIONS section. If you do not have
electrical wiring experience, refer to a do-it-yourself wiring handbook or
have your fixture installed by a qualified licensed electrician.
GENERAL
- Be sure to read these instructions and review the diagrams thoroughly before beginning.
- Electrical connections must be in accordance with local codes, ordinances, or the National Electric Code. If you are unfamiliar with methods of installing electrical wiring, secure the services of a qualified licensed electrician.
- Before starting the installation, disconnect the power by turning off the circuit breaker or by removing appropriate fuse at fuse box. Turning the power off at the light switch is not sufficient to prevent electrical shock.
PREPARE THE FIXTURE
NOTE: First turn off electricity.
- IF replacing an existing fixture, disconnect and remove old fixture. Expose the supply wiring from outer fixture.
- If your fixture is supplied with three machine screws, thread the long machine screws into the opposite side of outer fixture. While supporting the fixture, make electrical connections.
ELECTRICAL CONNECTIONS 120V -, 60Hz
Connect white wire(s) from fixture to white neutral wire from supply circuit.
Connect black wire(s) to black hot wire from supply circuit. Connect green
wire to green or bare wire or grounding screw on mounting bracket. In all
cases grounding conductor to earth must be used. Use UL/CSA Listed wire
connects suitable for the size, type, and number of conductors. No loose
strands or loose wires should be present. Secure wire connectors with UL/CSA
Listed electrical tape.
FINAL ASSEMBLY
- Spread electrical splices so black wires are on one side of outlet box and white wires on the other.
- Attach assembled unit to outer fixture by using three screws and brass nuts, or the threaded stem with nut provided.
- Install light bulbs (not provided) and cover assembly. Some models employ a twist off top cap to allow access to bulbs.
- CAUTION: Refer to the revamping label located near lamp holder for recommended maximum wattage. Do not exceed recommended wattage.
- Use weather resistant caulk to seal around top and side perimeter of fixture back plate. Leave bottom uncaused to allow for condensation evaporation.
- Restore electrical power.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>