Maxxima MRL-412505 4 Inch LED Rotatable Retrofit Kit Installation Guide

June 14, 2024
Maxxima

Maxxima MRL-412505 4 Inch LED Rotatable Retrofit Kit

Maxxima-MRL-412505-4-Inch-LED-Rotatable-Retrofit-Kit-
product

Product Installation Instructions

  1. Ensure the power has been turned off by switching the circuit breaker to the off position or by removing the fuse from the fuse panel.
  2. If replacing an existing fixture, remove and disconnect the existing fixture from the housing.
  3. Select the desired color temperature by moving the selector switch shown in Figure 1.
  4. Twist the E26 adapter into the housing as shown in Figure 2.
  5. Connect the orange connector to the E26 adapter as shown in Figure 3.
  6. Tuck all wires into the housing and carefully push the LED trim until its outer edge is flush against the ceiling surface. Start by pushing one mounting plate against the inside of the housing until the other plate can be positioned and pushed up into the housing. Refer to Figure 4 for visual guidance.
  7. Restore power and the light is now operational.

FAQ

  • Q: What is the warranty period for the product?
    • A: Maxxima extends a 3-year limited warranty to the original purchaser that the products listed are free from defects in material and/or workmanship. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails due to defects due to workmanship and/or materials within the limited warranty period.
  • Q: Is the warranty transferable?
    • A: No, the limited warranty is not transferable and applies to the original installation of the Maxxima product.
  • Q: How can I contact Maxxima for further assistance?
    • A: You can contact Maxxima via email at [email protected] or by phone at 866-MAXXIMA (629-9462).
  • Q: Where is Maxxima located?
    • A: Maxxima is located at 125 Cabot Court Hauppauge, NY 11788.

WARNINGS

  • Risk of electric shock or fire – Disconnect power at the source before installation.
  • If you are unsure about the installation or the maintenance of the fixture, please consult an electrician.
  • Do not make or alter any holes in the wiring enclosure or modify any electrical componentry.
  • To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.

CAUTIONS

  • The fixture must be wired in accordance with the National Electric Code (N.E.C) standards and any applicable local codes or ordinances.
  • This fixture is suitable for DAMP locations.
  • This fixture is designed for use with 120Vac, 50/60Hz only.
  • The retrofit kit is accepted as a component of a luminaire where the suitability of the combination shall be determined by CSA or authorities having jurisdiction.

Specification

Electrical Parameters

Model| Input

Voltage

| Input

Frequency

| Input

Current

| Input

Wattage

---|---|---|---|---
MRL-412505| 120 VAC| 60 Hz| 80 mA| 10 W
MRL-412505B

Product Dimensions

Maxxima-MRL-412505-4-Inch-LED-Rotatable-Retrofit-Kit-
fig-1

INSTALLATION INSTRUCTIONS

  1. Ensure the power has been turned off by switching the circuit breaker to the off position or by removing the fuse from the fuse panel.
  2. If replacing an existing fixture remove and disconnect the existing fixture from the housing.
  3. Select the desired color temperature by moving the selector switch shown in figure 1.
  4. Twist the E26 adapter into the housing as shown in figure 2.
  5. Connect the orange connector to the E26 adapter as shown in figure 3.
  6. Tuck all wires into the housing and carefully push the LED trim until its outer edge is flush against the ceiling surface. Start by pushing one mounting plate against the inside of the housing until the other plate can be positioned and pushed up into the housing. Seen in figure 4.
  7. Restore power and the light is now operational.

WARRANTY

3 YEAR WARRANTY

Maxxima extends a 3 year limited warranty to the original purchase that the products listed are free from defects in material and/or workmanship only. Maxxima will replace any warrantied product to the original consumer/purchaser if the product fails because of defects due to workmanship and/or materials within the limited warranty period. Limited warranty is not transferable and applies to the original installation of the Maxxima product. This offer does not constitute in any way a product guarantee and Maxxima does not hereby assume any obligation whatsoever beyond sending a free replacement product.

Contact

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

Maxxima User Manuals

Related Manuals