Nanoleaf Shapes Mini Triangle Expansion Pack User Manual

Nanoleaf Shapes Mini Triangle Expansion Pack

Product Information

Specifications:

• Product: Nanoleaf Shapes
• Function: Smart lighting panels
• Connectivity: WiFi
• Supported Networks: Single WiFi network at a time

Product Usage Instructions

Soft Reset:

1. Ensure that your Shapes installation is plugged into a wall outlet and has booted up. During bootup, all hexagons should be white.
2. Press and hold the Power and Plus buttons simultaneously for 10 seconds.
3. The button LEDs on the controller will start flashing rapidly.
4. Release the two buttons after a few moments.
5. Wait until the Power button LED remains on and steady.
6. Delete the previous device from the app.
7. Proceed with the setup process by adding the Hexagon as a new device.

Hard Reset:

1. Disconnect the system from power by unplugging it from the wall.
2. While holding the Power and Plus buttons, plug the power supply back into power.
3. Continue holding the buttons down until the button LEDs on the Controller light up.
4. Once the button LEDs come on, release the buttons. The button LEDs will flash to indicate that a hard reset will now take place.
5. The controller will reset to factory defaults and boot up.
6. The Hexagon is ready to be set up once the Power Button LED stops flashing and the panels begin cycling through different colors.

TwoWay Sync:
The TwoWay Sync feature can be used to back up and restore any custom Scenes that you’ve created. Refer to the product manual for detailed instructions on using this feature.

FAQ (Frequently Asked Questions)

• Q: Can I connect my Nanoleaf Shapes to multiple WiFi networks?
  A: No, your Nanoleaf Shapes can only be connected to one WiFi network at a time.

• Q: Will a soft reset delete my saved scenes?
  A: No, a soft reset will only reset the WiFi and pairing information for your Shapes. Your saved scenes will be retained.

• Q: How do I perform a hard reset on my Nanoleaf Shapes?
  A: To perform a hard reset, disconnect the system from power, then while holding the Power and Plus buttons, plug the power supply back in. Continue holding the buttons until the button LEDs on the Controller light up. Release the buttons and wait for the hard reset to complete.

Soft & Hard Reset Nanoleaf Shapes

Your Nanoleaf Shapes can only be connected to one WiFi network at a time. The following steps will reset your Hexagons so they can be configured onto a new network or reset to factory settings.

Soft Reset

This will reset WiFi and all pairing information for your Shapes but will keep your saved scenes.

1. Make sure that your Shapes installation is plugged into the wall outlet and has booted up (during bootup, all hexagons are white).
2. Press and hold the Power and Plus buttons for 10 seconds. The button LEDs on the controller will start flashing rapidly.
3. Release the two buttons, and after a few moments, the Power button LED will remain on and steady.
4. Delete the previous device from the app and proceed through setup by adding the Hexagon as a new device.

Hard Reset

This will reset your Shapes to factory settings, deleting all WiFi settings and pairing data. Default scenes will be restored from the device’s memory. The Two-Way Sync feature can be used to back up and restore any custom Scenes that you’ve created. See below.

To perform a Hard Reset:

1. Disconnect the system from power (unplug from the wall).
2. While holding the Power and Plus buttons, plug the power supply back into power.
3. Continue holding the buttons down until the button LEDs on the Controller light up.
4. Once the button LEDs come on, release the buttons. The button LEDs will flash to indicate that a hard reset will now take place.
5. The controller will reset to factory defaults and boot up.
6. The Hexagon is ready to be set up once the Power Button LED stops flashing and the panels begin cycling through different colors.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>