Nanoleaf A60 Factory Reset Light Strip Instructions
- June 14, 2024
- nanoleaf
Table of Contents
Nanoleaf A60 Factory Reset Light Strip
How To Factory Reset Your Nanoleaf Essentials?
The Nanoleaf Essentials devices only have a factory reset mechanism. This resets all user pairing and network information. This is performed differently between bulbs and light strips. “Turn off/on” refers to physically powering on/off the device with a switch.
Bulb (A19)
Turn off, wait for 3 seconds, and turn back on for no more than 3 seconds. Repeat for a total of 5 power cycles. The bulb will flash red three times if successful.
Light Strip
Hold the power and brightness up (+) buttons on the controller for 5 seconds. Note that these buttons must be pressed simultaneously – pressing one and then the other after and holding will not work. This is by design so that it’s more difficult to accidentally trigger a reset. The strip will flash white three times if successful.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>