FORTIN EVO-ONE-942 2-Way Remote Starter User Guide

: June 13, 2024
: FORTIN

Table of Contents

SPECIFICATION
REMOTE STARTING
REMOTE STARTING FROM FACTORY KEY FOB
WHEN SERVICING THE VEHICULE
FROM THE ANTENNA
FROM THE REMOTE
KEY TAKEOVER AFTER REMOTE STARTING*
ALARM DIAGNOSTICS*
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

FORTIN EVO-ONE-942 2-Way Remote Starter

FORTIN EVO-ONE-942 2-Way Remote Starter QUICK PRESS 0.5 SEC.

LONG PRESS 3 SEC.

FRM942-2W: 2-WAYS REMOTE: FCC ID: 2ACKU-RM942 / IC: 12084A-RM942
ANT900: ANTENNA: FCC ID: 2ACKU-ANT900 IC: 12084A-ANT900
MADE IN CANADA / DOC.#69571 / REV: G20231017 / © 2017 ALL RIGHTS RESERVED

SPECIFICATION

BUTTON| COMMAND| TIME PRESSED SECON| CONFIRMATION| DESCRIPTION
---|---|---|---|---
| LOCK| 0.5 SEC.| 1 beep

1 Green flash

The remote start has failed.

WHEN THE REMOTE’S BLUE LED FLASHES 6 TIMES AND THE RED LED IS ON FOR ONE SECOND:
WHEN THE REMOTE EMITS A LONG BEEP AND THE RED LED IS ON FOR ONE SECOND
IF THE REMOTE EMITS 2 OR MORE DESCENDING SOUNDS AFTER ANY BUTTON IS PRESSED:

The vehicle is out of range.

The remote’s buttons are DISABLED.

The batteries inside the remote are weak and will need replacing. *Replacement batteries sold separately

REMOTE STARTING

When leaving the vehicle it is recommended that the driver pre-set the climate controls in preparation for a later remote start. To remote start the vehicle :

STEP 1

To remote-start the vehicle press the START button for approximately 3 second The remote Green Led flash and a ascending melodie will sound to confirm

STEP 2

Approximately 5 seconds later the engine will crank and run for the selected runtime (15 minutes by default).

If the vehicle fails to start on the first attempt, the Remote-Starter will wait 3 seconds before it will attempt to start the vehicle again. The Remote- Starter will attempt to start the vehicle 2 times (default) before giving up. (See Failed Remote Start, on the complete user guide).
RUNTIME : On gas engines the Remote-Starter can run the vehicle for either 15 (default), 3 or 7 minutes. On diesel engines either 30 (default), 6, or 15 minutes.

REMOTE STARTING FROM FACTORY KEY FOB

IF OPTION AVAILABLE. To remote start the vehicle with the factory key fob :

PRESS LOCK 3 TIMES (By default) or PRESS LOCK UNLOCK LOCK.

Remote-start the vehicle.

WHEN SERVICING THE VEHICULE

Valet Mode disables the remote starter and alarm. Whenever the vehicle is being serviced, repaired or the vehicle is parked indoors; it is mandatory that Valet Mode be enabled to prevent an accidental remote start.

FROM THE ANTENNA

STEP 1

Turn the vehicle ignition to (ON/RUN) position. The vehicle does not need to be started.

STEP 2

Within 10 seconds press and release the button on the antenna 3 times.

FROM THE REMOTE

Press and release the FUNCTION button, and than press simultaneously the LOCK and UNLOCK.
VALET MODE ENABLED: The LED is ON VALET MODE DISABLED: The LED is OFF

KEY TAKEOVER AFTER REMOTE STARTING*

**KEY TAKEOVER FOR STANDARD KEY VEHICLE***

STEP 1		Do not press the foot brake (the engine will shut down).
STEP 2		Insert the key into the ignition and turn to ON position.
STEP 3		Press the foot brake.

**KEY TAKEOVER FOR PUSH-TO-START VEHICLE***

STEP 1

FORD / HYUNDAI / INFINITI / KIA / MAZDA / NISSAN / SUBARU*

STEP 2

| Enter the vehicle with the SMART-KEY.

**STEP 3

**

| Do not press the foot brake.

**STEP 4

**

| Press and release the Push-to-Start button once.

**STEP 5

**

| Press the foot brake.

STEP 6 **

**

| The vehicle can now be put in to gear and driven.
If the Smart- Key is not detected the vehicle will shut down.

UNLOCK the doors with either the OEM remote, the remote-starter remote or the proximity remote*.

**ACURA / HONDA / LEXUS / SCION TOYOTA ***

STEP 2

The module will shut down the vehicle as soon as the drivers door is opened

**AUDI / BMW / CHRYSLER / GMC***

Press the foot brake.
STEP 3

The vehicle can now be put in to gear and driven.

*The remote starter key takeover may vary by vehicle, ask your adviser or technician for details.

**REMOTE START DIAGNOSTICS***

| Parking Light flashes (before starting):
---|---
3x| Ready mode disabled
4x| Valet mode activated (The LED is on)
5x| Hood open
| Parking Light flashes (after Shutdown):
1x| Normal stop (Brake, Park Brake)
3x| Runtime expired or shut down by transmitter
4x| No tachometer signal
5x| Hood open
6x| Fail to start

ALARM DIAGNOSTICS*

| ALARM DIAGNOSTICS
---|---
3x| ALARM DIAGNOSTICS
4x| Shock sensor – zone 4
5x| Hood open – zone 5
6x| Trunk open – zone

*The parking light diagnostics can not be used on some vehicles equipped with automatic lights.

RANGE

Up to 2 KM / 6500Ft range

BATTERY

BATTERY REQUIRED: 2x CR2016
AVERAGE BATTERY LIFE: 24 months

THANK YOU FOR PURCHASING THIS REMOTE-STARTER/ALARM SYSTEM.
WE RECOMMEND THAT YOU DOWNLOAD AND THOROUGHLY REVIEW THE COMPLETE USER MANUAL FOR MORE INFORMATION ABOUT THE REMOTE STARTER / ALARM SYSTEM AT: evoremotestart.com/rm942
CAUTION WARNING

IT IS THE RESPONSIBILITY OF THE REMOTE CAR STARTER OPERATOR TO:

ensure that the vehicle is parked in a safe and responsible manner.
ensure that the vehicle is not remotely started indoors (garage, underground parking).
ensure that the vehicle is not remotely started with a passenger inside.
ensure that the vehicle is not remotely started with a window or the roof open.
ensure that the gearshift lever is in the NEUTRAL position and the parking brake is engaged on manual transmission in order to avoid accidents upon remote starting.
when leaving the vehicle, ensure that the gearshift lever is in the “PARK” position for an automatic transmission in order to avoid accidents upon remote starting. Make sure that the vehicle cannot start in “Drive” position.
ensure that the remote starter is disabled or put into valet mode before servicing. When servicing the vehicle, download the complete user guide for more information.