MORIMOTO X3B15 X3B Brake Light Installation Guide
- June 13, 2024
- MORIMOTO
Table of Contents
MORIMOTO X3B15 X3B Brake Light
WARNING: By reading this document, you agree it is only to be used as an educational guide. Morimoto Lighting nor its dealers make guarantees on any finished results, nor are they to be held responsible for any damage, misuse, or personal injuries. If you are unable to clearly understand and adapt the information below, professional installation is recommended.
PACKAGE CONTENTS
TOOLS REQUIRED
1OMM SOCKET WITH EXTENSIONS THIN TRIM PRY TOOL
INSTALLATION PRICESS
- Slightly pull back the headliner inside the cab nearest the rear glass (Image 1). Using a trim removal tool, release the two push clips holding the headliner to the roof (Image 2).
- Remove the two 10mm nuts holding the third brake light to the cab.
- Using the trim removal tool, carefully wedge the tool between the brake light and the cab, loosening the foam seal from the cab in the process (Image 1). Once the foam seal has been fully broken, remove the brake light from the truck (Image 2).
- Unplug the factory connector and remove the third brake light from the truck. Scrape off excess foam from the truck using a plastic razor blade.
- For steps on installing the Rapid Flash Module (SKU X3B01), see Page 4.
- Installation is reverse of removal.
- Turn on the truck and go through all modes to ensure proper functionality.
RAPID FLASH MODULE INSTALLATION
- Unclip the wiring harness from the back of the X3B Brake Light (Image 1)
- Plug the female connector into the X3B Brake Light (Image 2)
- Plug X3B Brake Light harness into male connector of the flasher module.
- Peel back wear resole tided treenshe the module stick and secure module onto
- Turn on the truck and go through all modes to ensure proper functionality.
- Enjoy your new X3B Brake Light with Rapid Flash!
INFO@MORIMOTOLIGHTING.COM
MORIMOTOLIGHTING.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>