MORIMOTO X3B20 1x Third Brake Light Instruction Manual
- June 13, 2024
- MORIMOTO
Table of Contents
MORIMOTO X3B20 1x Third Brake Light
09-1 4 F-1 50 / RAPT R X3B THIRD BRAKE LIGHT INSTALLATION GUIDE
WARNING : By reading this document, you agree it is only to be used as an
educational guide. Morimoto Lighting nor its dealers make guarantees on any
finished results, nor are they to be held responsible for any damage, misuse,
or personal injuries. If you are unable to clearly understand and adapt the
information below, professional installation is recommended.
PACKAGE CONTENTS
-
1 X THIRD BRAKE LIGHT
-
OPTIONAL X3BO1 RAPID FLASH MODULE
TOOLS REQIIRED
-
2 PHILIPS SCREWDRIVER
INSTALLATION PROCESS
- Remove the 2 (two) Philips screws holding the brake light in place. Pull brake light away from vehicle.
- Press the clip out to remove the stock connector. Depress the tab and pull the connector out to remove.
- For steps on installing the Rapid Flash Module (SKU X3B01), see Page 3.
- Installation is the reverse of removal. Use the included screws to replace the factory screws.
- Turn on the truck and go through all modes to ensure proper functionality.
RAPID FLASH MODULE INSTALLATION
- Unclip the wiring harness from the back of the X3B Brake Light (Image 1)
- Plug the female connector into the X3B Brake Light (Image 2)
- Plug the X3B Brake Light harness into the male connector of the flasher module.
- Peel back the wrapper from double-sided tape on the flasher module. Stick and secure the module onto either the back of the X3B Brake Light or the inside of the light cavity.
- Turn on the truck and go through all modes to ensure proper functionality.
- Enjoy your new X3B Brake Light with Rapid Flash!
INFO@MRIMDTDLIGHTING.CDM
MORIMDTDLIGHTING.CDM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>