MORIMOTO X3B45 LED Third Brake Light Installation Guide
- June 13, 2024
- MORIMOTO
Table of Contents
MORIMOTO X3B45 LED Third Brake Light
- 14-18 SILVERADO / SIERRA
- X3B THIRD BRAKE LIGHT
INSTALLATION GUIDE
WARNING: By reading this document, you agree it is only to be used as an educational guide.
- Morimoto Lighting nor its dealers make guarantees on any finished results, nor are they to be held responsible for any damage, misuse, or personal injuries.
- If you are unable to clearly understand and adapt the information below, professional installation is recommended.
PACKAGE CONTENTS
TOOLS REQUIRED
- T 20 TORX SCREWDRIVER
INSTALLATION PROCESS
- Remove the 2 (two) T20 Torx screws holding the brake light in place. Pull the brake light away from the vehicle.
- Unplug the factory connector and remove the third brake light from the truck.
- For steps on installing the Rapid Flash Module (SKU X3B01),.
- Installation is the reverse of removal.
- Turn on the truck and go through all modes to ensure proper functionality.
RAPID FLASH MODULE INSTALLATION
- Unclip the wiring harness from the back of the X3B Brake Light (Image 1)
- Plug the female connector into the X3B Brake Light (Image 2)
- Plug the X3B Brake Light harness into the male connector of the flasher module.
- Peel back the wrapper from double-sided tape on the flasher module. Stick and secure module onto either the back of the X3B Brake Light or the inside of the light cavity.
- Turn on the truck and go through all modes to ensure proper functionality.
- Enjoy your new X3B Brake Light with Rapid Flash!
CONTACT
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>