Morimoto Lighting LED153 Bluetooth LED Device App User Manual
- June 5, 2024
- Morimoto Lighting
Table of Contents
Lighting LED153 Bluetooth LED Device App
User Manual
LED153 Bluetooth LED Device App
Bluetooth LED DEVICE APP Application OF Mobile phones
-
How to use a new Bluetooth-led device and Application ?
1. How to use a new Bluetooth-led device and Application?
A: Open Bluetooth service from phone settings or Bluetooth application. Then switch on Bluetooth led device(LedBle ), then you can use this App to control it.
1. First of all, install the App in a mobile phone -
Which types of equipment are supported by the current Application?
A: Android devices and Apple devices with system version above 4.3 and with BLe can work with this application. -
How far can I control Bluetooth-led devices with the phone?
A: Normally, the range is 18-30m without obstructions. -
How many led devices can I control at the same time?
A: You can control 6 PCS at the same time, you can add devices to different groups defined by yourself. -
How can I ADD a device to a group?
A: After adding a new group, click the group with the switch is off. If there are some devices in the group, you must close the switch. -
Why can’t scan out the Bluetooth LED device?
A:1. Double check the Bluetooth-led device’s power is on or not.2. Metal can shield the Bluetooth signal If you install the Bluetooth-led device to metal lanterns, the Bluetooth-led device may not come out from the App. 3. For a Bluetooth-led device, only one phone can control it at the same time, do not use more phone to control one device at the same time.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment
should be installed and operated with a minimum distance of 20cm from the
radiator and your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>