MORIMOTO X3B25 LED Third Brake Light Installation Guide
- June 13, 2024
- MORIMOTO
Table of Contents
MORIMOTO X3B25 LED Third Brake Light
WARNING: By reading this document, you agree it is only to be used as an
educational guide.
Morimoto Lighting nor its dealers make guarantees on any finished results, nor
are they to be held responsible for any damage, misuse, or personal injuries.
If you are unable to clearly understand and adapt the information below,
professional installation is recommended.
PACKAGE CONTENTS
TOOLS REQUIRED
- 2 PHILIPS SCREWDRIVER
- OPTIONAL X3B01 RAPID FLASH MODULE
INSTALLATION PROCESS
- Remove the 2 (two) Philips screws holding the brake light in place. Pull the brake light away from the vehicle.
- Unplug the factory connector and remove the third brake light from the truck.
- For steps on installing the Rapid Flash Module (SKU X3B01),
- Installation is the reverse of removal. Use the provided screws to install the new brake light.
- Turn on the truck and go through all modes to ensure proper functionality.
RAPID FLASH MODULE INSTALLATION
- Unclip the wiring harness from the back of the X3B Brake Light (Image 1)
- Plug the female connector into the X3B Brake Light (Image 2)
- Plug the X3B Brake Light harness into the male connector of the flasher module.
- Peel back the wrapper from double-sided tape on the flasher module. Stick and secure the module onto either the back of the X3B Brake Light or the inside of the light cavity.
- Turn on the truck and go through all modes to ensure proper functionality.
- Enjoy your new X3B Brake Light with Rapid Flash!
Documents / Resources
|
MORIMOTO X3B25 LED Third Brake
Light
[pdf] Installation Guide
X3B25 LED Third Brake Light, X3B25, LED Third Brake Light, Third Brake Light,
Brake Light, Light
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>