Z-Lite 597PHB-519P-BK Laurent 109 Inch Tall Outdoor Post Lamp Instruction Manual
- June 13, 2024
- Z-Lite
Table of Contents
597PHB-519P-BK Laurent 109 Inch Tall Outdoor Post Lamp
Instruction Manual
597PHM & 599PHM & 597PHB & 599PHB & 597MP3
599MP3 & 597BP3 & 599BP3
597MP6 & 599MP6 & 597BP6
& 599BP6
FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING
ON IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF.
GENERAL You don’t need special tools to install this fixture. Be sure to
follow the steps in the order given. Under no circumstances should a fixture
be hung on house electrical wires, nor should a swag type fixture be installed
on a ceiling which contains a radiant type heating system. Read instructions
carefully. If you are unclear as to how to proceed, consult a qualified
electrician.
NOTE: Proper wiring is essential for the safe operation of this fixture.
ASSEMBLY INSTRUCTIONS
READ & SAVE
INSTALLATION & OPERATION INSTRUCTIONS TOOLS & MATERIALS REQUIRED
| Screwdriver | Wire Cutters |
|---|---|
| Adjustable Wrench | Wiring Supplies |
CAUTION
Prior to assembly, refer to ELECTRICAL CONNECTIONS section. If you do not have
electrical wiring experience, refer to a do-it-yourself wiring handbook or
have your fixture installed by a qualified licensed electrician.
GENERAL
- Be sure to read these instructions and review the diagrams thoroughly before beginning.
- Electrical connections must be in accordance with local codes, ordinances, or the National Electric Code. If you are unfamiliar with methods of installing electrical wiring, secure the services of a qualified licensed electrician.
- Before starting the installation, disconnect the power by turning off the circuit breaker or by removing appropriate fuse at fuse box. Turning the power off at the light switch is not sufficient to prevent electrical shock.
PREPARE THE FIXTURE
NOTE: First turn off electricity FINAL ASSEMBLY
-
Pull the black, white and ground wires out of mounting post.
-
While supporting the fixture, connect electrical wires. If your post has a ground wire (green or bare copper), connect the fixture ground wire to it. If not, consult your electrician for proper grounding.
ELECTRICAL CONNECTIONS 120V~, 60Hz
Connect white wire(s) from fixture to white neutral wire from supply circuit.
Connect black wire(s) to black hot wire from supply circuit. Connect green wire to green or bare wire or grounding screw on mounting bracket. In all cases grounding conductor to earth must be used. Use UL/CSA Listed wire connects suitable for the size, type, and number of conductors. No loose strands or loose wires should be present. Secure wire connectors with UL/CSA Listed electrical tape.
After wires are connected, tuck them carefully inside the post cup. -
Align the lantern with mounting post and secure with screws
-
Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the light switch on to activate the fixture.
-
Glass replacement. Twist the glass part. Remember to add the gasket ring, gasket packaged in the spare parts bag.
CAUTION: LED fixtures can operate at high temperatures please use caution
when touching during operation or after operation.
Please observe local building/electrical codes regarding the installation of
your post fixture. Please keep in mind your geographic location and the depth
that the ground freezes to, when deciding the depth of your installation
