MINKA LAVERY 4584-672 Caprio 4 Light 24 Wide Multi Light Pendant Instruction Manual

INSTALLATION INSTRUCTION FOR FIXTURE #4584-672

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

ASSEMBLY THE FIXTURE (FIG. 1 & FIG. 3)

1. Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
3. Attach crystal ball (T) onto tube (S).
4. Install fabric shade (M) on arms (R) using metal nuts (N) and place decorative ring (L）on fabric shade (M).
5. Determine the desired height and thread rods (G1 and G2) together. Screw loop (I1) to the rod (G1). Pass the wires carefully through each rod as you assemble. Attach the bottom end of rod into the coupling (J).
6. Attach quick link (H) to loop (I2) on canopy (D). Carefully feed the wire through loop (I1), quick link (H), and loop (I2).
7. Attach circular strap (B) to the junction box using the junction box screws (C). The side of the circular strap (B) marked “GND” must face out. Mounting screw can be adjustable if necessary.
8. The support cable is provided to support the weight of the fixture while wiring. Align the fixture to circular strap (B) and attach hook on the end of support cable (E) into a slot located on circular strap (B). Carefully allow the support cable (E) to support the weight of the fixture while wiring.

CONNECTING THE WIRES (FIG. 2)

9. Connect the electrical wires as shown in figure 2, makingsure that all wire connectors are secured. If your junction box hasa ground wire (green or bare copper), connect the fixture’s groundwire to it. Otherwise, connect the fixture’s ground wire directly tothe circular strap (B) using the green screw provided.
10. Tuck the wire connectors neatly into the junction box.

COMPLETING THE INSTALLATION (Fig. 1)

11. Raise the fixture over the mounting screws (A) and securewith decorative nuts (F).
12. Place candle covers (Q) over sockets (V), then place tubecovers (K) over candle covers (Q). Install (4) four candelabra basebulbs (X) up to 60 watts each or CFL or LED equivalent (notincluded) in accordance with the fixture specification—DO NOTEXCEED THE MAXIMUM WATTAGE RATING! (NE PASDEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
13. Attached leaf finial (O) with coupling (P).

The leaves on the lamp body can be manually adjusted to changetheir shape.
Your installation is now complete. Turn on the power supply of thejunction box to test the fixture. Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased. a. Hardware Bag:
A. Mounting Screw2
B. Circular Strap1
C. Screw2
D. Canopy1
F. Decorative Nuts2
H. Quick Link1
I. Loop2
AA. Hex Nuts2 b. Hardware Bag:
G1. ROD 6″1
G2. ROD 12″3

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>