Z-Lite 1944F22 RB LED Anders Flush Mount Ceiling Light Instruction Manual

Z-Lite 1944F22 RB LED Anders Flush Mount Ceiling Light

Product Information

• Product Name: Fixture
• Model Number: [Model Number]
• Manufacturer : [Manufacturer]

Product Usage Instructions

1. Before starting the installation process, ensure that the power is shut off at the circuit breaker box to avoid any risk of electrical shock.
2. Remove the old fixture and all hardware from the Outlet Box.
3. Unpack your new fixture carefully and lay out all the parts in a clear area, ensuring that no small parts are lost.
4. Hold the mounting plate up against the ceiling outlet box, aligning the outlet box with the two thread holes. Adjust it to the appropriate location and use a pencil to mark the anchor screw holes.
5. Remove the mounting plate and drill holes for the anchor screws. Load plastic anchors into the drilled holes.
6. Attach the mounting plate to the outlet box using the two outlet box screws and four anchor screws as shown. Make sure that the side of the mounting plate marked “GND” faces outward. Please note that the outlet box is not included.
7. Wire Connections:

   •   * Attach the fixture ground wire to the supply ground wire using a wire nut.

Please consult your local electrical codes for wiring and grounding requirements before proceeding with the installation.

ASSEMBLY AND INSTALLATION INSTRUCTIONS

WARNING: TO AVOID THE RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: Before installing, consult local electrical codes for wiring and grounding requirements.

Installation Steps:

1. Shut off the power at the circuit breaker box. Remove old fixtures and all hardware from the Outlet Box.
2. Carefully unpack your new fixture and lay out all the parts in a clear area.
   • Take care not to lose any small parts necessary for installation.
3. Hold the mounting plate up against the ceiling outlet box, align the outlet box with two thread holes, and adjust to the appropriate location, use a pencil to mark the anchor screw holes, remove the mounting plate, then drilled holes and load plastic anchors. Attach the mounting plate to the outlet box with the two outlet box screws and four anchor screws as shown. The side of the mounting plate marked “GND” must face out. The outlet box is not included.
4. NOTE: make wires connections:
   • Attach fixture ground wire to supply ground wire using a wire nut or attach them to the mounting plate with a green ground screw.
   • Attach fixture white wire from the lamp body to supply white wire or ridge wire from a power source with a wire nut.
   • Attach fixture black wire from the lamp body to supply black wire or smooth wire from a power source with a wire nut.
   • Observing: positive wire with positive wire, negative wire with negative wire, ground wire with ground wire.
5. Make sure all wire connectors are secured and do not easily pull off with a slight tug. After the wires are connected, tuck them carefully inside the Outlet Box.
6. Take this LED illuminant to the ceiling mounting plate, the magnet conglutinating with the mounting plate, then raise the power plug and insert the socket.
7. Install the diffuser into the shade frame, fixed with the iron sheets.
8. Attach the assembled shade onto the ceiling mounting plate, aligning the top studs of shade with the mounting plate’s slots, now, rotate the shade until the studs are seated in the slots.
9. Your installation is now complete. Return power to the outlet box and test the lamp body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>