Minka Lavery 5904-655 North Fork 6 Light Flush Mount Instruction Manual
- June 13, 2024
- MINKA LAVERY
Table of Contents
Minka Lavery 5904-655 North Fork 6 Light Flush Mount
PREPARATION
-
Shut off the power at the fuse box or circuit breaker. If necessary, remove the old fixture, including mounting hardware. Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration.
MOUNTING THE FIXTURE (Fig. 1) -
Secure crossbar (A) assembly and to junction box (not included) using mounting screws (B) (Size: #8-32N*L1”). The side of the crossbar (A) marked with “GND” must face out.
CONNECTING THE WIRES (Fig. 2) -
Connect the electrical wires as shown in Fig. 2 making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the crossbar (A) using the green screw provided.
-
Tuck wire connections neatly into the junction box. Raise canopy (C) to the junction box and secure with a finial (D).
FINISHING THE INSTALLATION (Fig.1) -
Secure “flower” (E) over the socket to the all-thread ring (F).
-
Install (6) six candelabra base bulbs up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification
DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!).
Your installation is now complete. Return power to the junction box and test
the fixture.
Note: The illustration (Fig. 1) in this manual is for installation
purposes only. It may or may not be identical to the fixture purchased.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>