MINKA LAVERY 2662-723 Colonial Charm 3-Light Old World Bronze Installation Guide
- June 13, 2024
- MINKA LAVERY
Table of Contents
MINKA LAVERY 2662-723 Colonial Charm 3-Light Old World Bronze
Product Information
The product is an indoor light fixture, identified by the item numbers 2662-723 and 2662-717. It is designed to be mounted on an outlet box and requires a power supply. The fixture can accommodate up to three candelabra base bulbs with a maximum wattage of 60 watts each. The fixture comes with a mounting plate, ground screw, and outlet box screw for installation.
Product Usage Instructions
- Before starting the installation process, make sure to shut off the power at the fuse box or circuit breaker.
- If there is an existing fixture, remove it along with its mounting hardware.
- Take the new fixture out of the carton and verify that all the parts are included.
- Adjust the arms of the fixture to the desired position, referring to the provided illustration.
- Attach the mounting plate to the outlet box using appropriate screws (not included).
- Connect the fixture wires:
- Black or smooth fixture wire to the black (hot) house wire.
- White or ribbed fixture wire to the white (neutral) house wire.
- Bare copper fixture wire (ground) to the green (ground) house wire.
- Install up to three candelabra base bulbs, not exceeding 60 watts each or using CFL or LED equivalents.
- Ensure that the installation is complete and secure.
- Restore power to the outlet box.
- Test the fixture to ensure it is functioning properly.
Note: The illustration provided in the manual (Fig. 1) is for installation purposes only and may not match the exact appearance of the purchased fixture.
INSTALLATION INSTRUCTIONS
Item#2662-723 2662-717 (New. 12/30/2022)
READ AND SAVE THESE INSTRUCTIONS
WARNING ! SHUT POWER OF FAT FUSE OR CIRCUIT BREAKER .
ASSEMBLING THE FIXTURE (Fig. 1)
-
Shut off the power at the fuse box or circuit breaker. If necessary, remove old fixture, including mounting hardware.
-
Carefully remove fixture from carton and check that all parts are included as shown in the illustration.
-
Adjust arms (I) to proper position. Refer to illustration (L).
MOUNTING THE FIXTURE (Fig. 2) -
Attach mounting plate to the outlet box (not included) with outlet box screws (Size: #8-32N*L1”). The side of the mounting plate with “GND” marked on it and two convex points must face out.
CONNECTING THE WIRES (Fig. 3) -
Connect the electrical wires as shown in Fig. 3 making sure that all wire connectors are secured. If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate using the green screw provided.
-
Tuck wire connections neatly into outlet box. Raise canopy to ceiling and secure with mounting screws.
FINISHING THE INSTALLATION (Fig.1) -
Place bobeches (K) over candle covers (J).
-
Hang wooden drops (N,P) on fixture body in proper position.
-
Thread finial (H) to fixture body and attach wooden drops (P).
-
Install (3) three candelabra base bulbs up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification—DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
Your installation is now complete. Return power to the outlet box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>