MINKA LAVERY 5903-655 North Fork by Robin Baron 3-Light Sand White Wall Sconce Instruction Manual
- June 13, 2024
- MINKA LAVERY
Table of Contents
MINKA LAVERY 5903-655 North Fork by Robin Baron 3-Light Sand White Wall
Sconce
INSTALLATION INSTRUCTIONS’
PREPARATION (Fig. 1)
-
Shut off the power at the fuse box or circuit breaker. If necessary, remove old fixture, including mounting hardware.
-
Carefully remove fixture from carton and check that all parts are included as shown in the illustration.
MOUNTING THE FIXTURE (Fig. 1) -
Attach mounting plate (A) to the junction box (not included) with junction box screws (B) (Size: #8-32N*L1”). The side of the mounting plate (A) with “GND” marked on it and two convex points must face out.
CONNECTING THE WIRES (Fig. 2) -
Connect the electrical wires as shown in Fig. 2 making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the green screw provided.
-
Tuck wire connections neatly into junction box. Attach back plate (D) to the junction box and secure with mounting screws (C).
FINISHING THE INSTALLATION (Fig.1) -
Secure “flower” (E) over the socket to the all thread ring (F).
-
Install (3) three candelabra base bulbs up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification—DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
Your installation is now complete. Return power to the junction box and test
the fixture.
Note : Illustration (Fig. 1) on this manual is for installation purposes
only. It may or may not be identical to the fixture purchased.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>