MINKA LAVERY 5037-66A Muncie 4-Light Black Candle Island Chandelier Instruction Manual
- June 13, 2024
- MINKA LAVERY
Table of Contents
MINKA LAVERY 5037-66A Muncie 4-Light Black Candle Island Chandelier
INSTALLATION INSTRUCTIONS
ASSEMBLING THE FIXTURE (Fig. 1)
-
Shut off power at the fuse box or circuit breaker and remove the old fixture, including mounting hardware.
-
Carefully unpack your new fixture from carton and check that all parts are included as shown in the illustration.
-
Determine the desired hanging height and thread rods (B & C) to coupling (D)，carefully feed wires through each rod as you assemble.
-
Attach fixture canopy (A) by threading onto rod (B).
HANGING THE FIXTURE (Fig. 2) -
Thread canopy screws into pre-drilled holes in circular strap.
Spaced same distance apart as holes in canopy (A), and secure with the nuts provided. The length of canopy screws may be adjusted if necessary. -
Attached circular strap to outlet box (Not included) using mounting screws (Size: #8-32N*L1”). The side of circular strap marked with “GND” must face out.
CONNECTING THE WIRE (Fig. 3 & 2) -
Connect the electrical wire as shown in Fig. 3, making sure that all wire connectors are secured. If your outlet box has a ground wire (green or bare copper), connect fixtures ground wire to it. Otherwise, connect fixture ground wire directly to circular strap
using green screw provided. -
Tuck wire connections neatly into the outlet box and then raise canopy all the way to the ceiling.
-
Raise canopy (A) over canopy screws and secure with cap nuts. (Fig.2)
FINISHING THE FIXTURE (Fig.1) -
Install (4) four candelabra base bulbs (E) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification — DO NOT EXCEED THE MAXIMUM WATTAGE RATING
Your installation is now complete. Return power to the outlet box and test the
fixture.
Note: Illustration (Fig.1) on this manual is for installation purposes
only. It may or may not be identical to the fixture purchased.