MINKA LAVERY 6411-66A-L Vantage 1-Light Black CCT LED Vanity Light Instruction Manual
- June 13, 2024
- MINKA LAVERY
Table of Contents
MINKA LAVERY 6411-66A-L Vantage 1-Light Black CCT LED Vanity Light
Product Information:
The product is a lighting fixture with the following item numbers: 6411, 6412, 6413-84, 66A-L. It is available in different color temperatures (CCTs) including 2700K, 3000K, 3500K, 4000K, and 5000K. The fixture is dimmable with ELV and/or LED compatible wall dimmer switches.
Product Usage Instructions
- Before starting the installation, make sure to shut off power at the fuse box or circuit breaker box.
- Remove the old fixture, including the mounting hardware.
- Take out the new fixture from the carton and ensure that all parts are included.
- Loosen the mounting screws (B) and remove the mounting plate (A) from the fixture. Note: Do not remove any other parts.
- Attach the mounting plate (A) to the junction box (not included) using the provided junction box screws (C) (Size: 832*1”L).
- Connect the electrical wires as shown in Fig. 2. Ensure that all wire connectors (D) are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the provided green screw.
- Tuck the wire connectors neatly into the junction box.
- Select the desired color temperature (CCT) by using the switch inside the canopy of the fixture.
- Align the back plate of the fixture onto the mounting plate (A) and secure it with the mounting screws (B).
- Once the installation is complete, restore power and test the fixture.
Note: It is recommended to have a qualified electrician install the fixture to ensure proper wiring and installation.
READ AND SAVE THESE INSTRUCTIONS
WARNING ISHUTPOWEROFFAT FUSEORCIRCUITBREAKER.
AVERTISSEMENT COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU
MOUNTING THE FIXTURE (Fig. 1)
- Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
- Carefully remove the new fixture from the carton and check that all parts are included as shown in the illustration.
- Loosen mounting screws (B). Remove mounting plate (A) from fixture. Note: Do not remove any other parts.
- Attach mounting plate (A) to junction box (Not included) using junction box screws (C) (Size: 8-32*1’’L). CONNECTION THE WIRES (Fig. 2)
- Connect electrical wires as shown in Fig. 2 making sure that all wire connectors (D) are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect fixture’s ground wire directly to mounting plate (A) using green screw provided.
- Tuck wire connectors neatly into the junction box. FINISHING THE INSTALLATION (Fig. 1)
- There are five CCTs (2700K / 3000K / 3500K / 4000K / 5000K) with this fixture. Select the desired CCT by using switch inside canopy of fixture.
- Align the back plate of fixture onto mounting plate (A) and secure with mounting screws (B).
Your installation is now complete. Return power and test the fixture.
IMPORTANT: THE FIXTURE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN TO
ENSURE PROPER WIRING AND INSTALLATION.
Dimming: Dimmable with ELV and/or LED compatible wall dimmer switches.