Minka Lavery 6201-66A Vantage 1 Light Black Metal Shade Pendant Instruction Manual

Table of Contents

Before starting the installation, ensure that the power is shut off at the fuse box or circuit breaker box.
Mounting the Fixture:
- Refer to Fig.1 for the mounting process.
- Securely mount the fixture by following the instructions shown in Fig.1.
Connecting the Wires:
- Refer to Fig.2 for the wire connections.
- Connect the electrical wires as shown in Fig.2.
- Ensure all wire connectors (A) are secured.
- If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it.
- If your outlet box does not have a ground wire, connect the fixture’s ground wire directly to the mounting plate (B) using the provided green screw.
- Neatly tuck the wire connections into the outlet box.
Finishing the Installation:
- Refer to Fig.1 for the finishing steps.
- Place the canopy (E) over the mounting plate (B).
- Secure the canopy with screws (D).
- Install one medium base (E26) bulb (G) up to a maximum of 60 watts, or use CFL or LED equivalent bulbs (not included) as per the fixture specifications.
- Ensure not to exceed the maximum wattage rating.
Once the installation is complete, restore power and test the fixture.

Note : The illustration in Fig.1 is for installation purposes only and may or may not be identical to the fixture purchased.

IMPORTANT : It is recommended to have the fixture installed by a qualified electrician to ensure proper wiring and installation.

READ AND SAVE THESE INSTRUCTIONS

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

(Fig.1)

Shut off power at the fuse box or circuit breaker box 1a. n d remove the old fixture, including the mounting hardware.
Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to misplace any small parts necessary for installation.
Attach the mounting plate (B) to outlet box (not included) using outlet box screws (C) (SIZE: #8-32N, L0.5″). The side of the mounting plate (B) marked “GND” must face out.
Adjust wire to desired hanging length using the small screw located on side of wire grip (F) with a flathead screwdriver (not included). Ensure to re-tighten set screw after wire adjustment. To straighten cord, please use a blow dryer (not included) if necessary.
Remove any excess wire leaving approximately 7″ beyond canopy (E) for wire connections.

(Fig.2)

Connect the electrical wires as shown in Fig.2, making sure that all wire connectors (A) are secured. If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect fixture’s ground wire directly to mounting plate (B) using green screw provided.
Tuck wire connections neatly into the outlet box.
FINISHING THE INSTALLATION (Fig.1)
Place canopy (E) over mounting plate (B) and secure with screws (D).
Install (1) one medium base (E26) bulb (G) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification
- DO NOT EXCEED THE MAXIMUM WATTAGE RATING!