MINKA LAVERY 9801 9-1-2 Inch 60W Medium Lantern Instruction Manual
- June 13, 2024
- MINKA LAVERY
Table of Contents
**MINKA LAVERY 9801 9-1-2 Inch 60W Medium Lantern Instruction Manual
**
INSTALLATION INSTRUCTIONS
MOUNTING THE FIXTURE (Fig.1)
-
Shut off the power at the circuit breaker box (advertisement! Couper le courant au Nivea des fusible out du disjuncture) and remove the old fixture, including the mounting hardware
-
Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
-
Attach the crossbar (part#A-010)to the junction box with the two mounting screws（size:8-32*1/2”L） as shown. The side of the crossbar marked “GND” must face out.
-
Thread the nipple part way into the center hole of the crossbar. The length of the nipple into the crossbar may be adjusted if necessary.
CONNECTING THE WIRES (Fig.2) -
Make sure all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the fixture’s ground wire to the crossbar with the green screw provided.
FIXTURE WIRES Black or Smooth HOUSE WIRES Black (Hot)
FIXTURE WIRES WHITE OR RIBBED HOUSE WIRES White (Neutral)
FIXTURE WIRES Green or Bare Copper (Ground)HOUSE WIRES Green or Bare Copper (Ground)
COMPLETING THE INSTALLATION (Fig.1)
-
Align the fixture back plate to the nipple and secure with the cap nut provided
-
Notice: To comply with UL Standards and maintain product warranty, use clear silicone sealant to outline the outside of the fixture back plate where it meets thewall to prevent moisture from entering the junction box while leaving a space at the bottom to allow moisture to escape (Fig 3.). Failure to do so will void any expressed warranty.
-
Install the light bulbs in accordance with the fixture’s
specification: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!（NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE） -
Place the glass with the marked arrow on the topside into the fixture and secure the steel glass support bar with the screws provided.
Your installation is now complete. Return power to the junction box and test the fixture.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>