MINKA LAVERY 1975-1 2-Light Wall Sconce User Manual
- June 13, 2024
- MINKA LAVERY
Table of Contents
INSTALLATION INSTRUCTIONS
For Model 1975-1
1975-1 2-Light Wall Sconce
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
MOUNTING THE BACKPLATE (Fig.1)
- Shut off the power at the circuit breaker and remove old fixture, including the crossbar.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- Attach the circular strap (A) to the outlet box using two outlet Box Screws (B). The side of the circular strap (A) marked “GND” must face out.
- Insert the threaded stud (C) provided, about 1/4”, into the circular strap (A). Align the stud (C) with the holes in the backplate (F).
CONNECTING THE WIRES (Fig. 2)
- At the point, connect the electrical wires as follow, Connect the black wire from the fixture to the black house (hot) wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has a ground wire (green or bare copper) connects fixture’s ground wire to it. Otherwise connect fixture’s ground wire directly to the crossbar using the green screw provided.
MOUNTING FIXTURE AND SHADE
- After the wires are connected tuck them carefully inside the outlet box as you place the backplate (F) over the stud(C). Secure the backplate (F) against the wall using Cap Nut (D).
- Install glass shade (E) by referring to fig.1.
- Install the bulb in accordance with the fixture’s specification. (DO NOT EXCEED THE MAXIMUM WATTAGE RATING!!).
Your installation is now complete. Return power to the junction box and test the fixture.
MIN 90℃ SUPPLY CONDUCTORS LA-1848E
Documents / Resources
|
MINKA LAVERY 1975-1 2-Light Wall
Sconce
[pdf] User Manual
1975-1 2-Light Wall Sconce, 1975-1, 2-Light Wall Sconce, Wall Sconce
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>