Minka Lavery 4601294 1 Light Semi Flushmount Ceiling Fixture Installation Guide
- June 13, 2024
- MINKA LAVERY
Table of Contents
Minka Lavery 4601294 1 Light Semi Flushmount Ceiling Fixture
Product Information
This product is a light fixture, item# 2255, designed for installation in residential or commercial buildings. It comes with a mounting plate, ground screw, mounting screws, and a glass shade. The fixture is compatible with standard electrical wiring and can accommodate light bulbs according to its specifications.
Product Usage Instructions
- Before starting the installation process, make sure to shut off the power at the fuse box or circuit breaker.
- Remove the old fixture, if necessary, along with its mounting hardware.
- Take out the new fixture from the carton and ensure that all parts are included as shown in the illustration.
- Attach the mounting plate (A) to the junction box using the provided mounting screws (B). Ensure that the side of the mounting plate with “GND” marked on it and two convex points is facing outwards.
- Connect the electrical wires as shown in figure 2. Secure all wire connectors properly. If your outlet has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate using the provided green screw.
- Install the light bulb(s) according to the fixture’s specifications. Ensure that you do not exceed the maximum wattage rating.
- Align the fixture body (C) over the mounting plate (A) and secure it with screws (D).
- Secure the glass shade (F) to the fixture body (C) using ball nuts (E).
- After completing the installation, restore power to the junction box and test the fixture.
Note: The illustration (Fig. 1) in the manual is for installation
purposes only and may or may not be identical to the fixture purchased.
Important: It is highly recommended to have the fixture installed by a
qualified electrician to ensure proper wiring and installation.
INSTALLATION INSTRUCTIONS
WARNING! SHUT THE POWER OFF AT THE FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE (Fig. 1)
-
Shut off the power at the fuse box or circuit breaker. If necessary, remove the old fixture including the mounting hardware.
-
Carefully remove the fixture from the carton and check that all parts are included as shown in the illustration.
-
Attach the mounting plate (A) to the junction box with mounting screws (B) (Size: #8-32N*L0.5”). The side of the mounting plate with “GND” marked on it and two convex points must face out.
CONNECTING THE WIRES (Fig. 2) -
At this point, connect the electrical wire as shown in figure 2, making sure that all wire connectors are secured. If your outlet has a ground wire (green or bare copper), connect the fixtures ground wire to it. Otherwise, connect the fixture ground wire directly to the mounting plate using the green screw provided.
COMPLETING THE INSTALLATION (Fig. 1) -
Install the light bulb(s) (not included) in accordance with fixture’s specifications. (DO NOT EXCEED THE MAXIMUM WATTAGE RATING!). (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
-
Align fixture body (C) over the mounting plate (A) and secure with screws (D).
-
Secure glass shade (F) to fixture body (C) with ball nuts (E).
Your installation is now complete. Return power to the junction box and test
the fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes
only. It may or may not be identical to the fixture purchased.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING AND INSTALLATION.